Separate names with a comma.
Some features disabled for guests. Register Today.
cool. electrical still flusters me till this day! You should get the 48v from two 24v pc supplies no problem, but the current capacity still has...
Haaa. It's like reading a huge headline. haha. No offense Kev
Well I'll be damned. It is physical! Could someone please enlighten me on the purpose of this contraption?
Yeah, this is pretty sweet. You should put it in a suitecase. :cool:
PC is better with compressive loads than delrin which acts a bit spongy. Introducing synthetic oil and/or grease such as that from some bearings...
Hello Boskap, Do you mean a tool touch off probe or do you want to physically limit the depth with a hard stop? Joe
Hey John, I think this is going to be handled on the hardware controller end. Any code received from the grbl control software will translate to...
Hey sw3Dp, I'm not an electrician. I work mechanical. From what I do know; this all depends on how you wire the DC side. If you wire them in...
So, those "drivers" are already heatsinked. One problem I've read on them is that there isn't thermal paste between the driver and heatsink. Some...
mach3 videos on yt. Paul Campbell is the. channel name....I think. The motors and drivers do get warm sometimes hot. They heat up the most when...
I'm using steel v-rail and wheels. The rail isn't as straight as you think it would be and spacers were too much of a hassle to get a hold of. I...
You nailed it. Crack propagation. The perfect stress concentrator is built in.
How many do you plan on making?
Hey Ophis, congrats on the buy. Good catch on the shaft size. That might've been a headache later! That board will get you by for now. At least...
[MEDIA] then there is something like this to help.
I put a copy of the nook acme screw critical speed chart in resources. It should help to determine screw size against rpm. Don't forget to...
Did you try on the warp9 forum or contact them?
itll take what it can based on the current pot settings. Just have to make sure the supply can provide the current.
I'm guessing you're using a combo board and drivers? The board should draw only the load it needs. you can hook up a 12v 20Amp to it and it'll be...
Did you figure out what the problem is?
