Separate names with a comma.
Some features disabled for guests. Register Today.
You haven't given us enough info to answer your question, but please DON'T spin any stepper motors by hand unless you have A) turned the power...
Absolutely do that - the case of your spindle MUST be connected to mains earth! Also check that pin 4 of the connector on the spindle is...
Just ignore the warning - it's just telling you that, as you didn't specify a wcs in the Fusion cam setup it is using the default of G54. Or, in...
Checking the obvious questions - did you A) enable homing, B) home the machine before running the job? Also you specified G55 in your cam software...
Where do you have the cable between the vfd and the spindle - if it's in the drag chain take it out and keep it as far away from other wiring as...
I only put a lot of effort into my first spoilboard (threaded inserts). After I threw that one away I use masking tape and superglue for almost...
The option for NO or NC firmware for the XproV5 refers to the door switch setting - $5 works fine with either version of the firmware. Alex.
Also, make sure you aren't overtightening the nut blocks to the gantry plate, and when you adjust them, tighten one to the plate, gently squeeze...
That depends to some extent on your router/spindle as well as the rigidity of your machine (which depends on how well you built it). I use a 20 mm...
Definitely try lubricating the leadscrew (dry ptfe or silicone spray ONLY) and running the leadscrew back and forth several times with a portable...
Sorry, you have exhausted my (very limited) expertise on this, but hopefully someone like @Peter Van Der Walt will be along soon with some truly...
Have you tried clicking to open it a second time? OB Control opens first in the background - the gui opens with the second click. Alex.
Which version of the Ooznest firmware did you upload? I'm not going to bother with the very latest version until I'm sure all the bugs have been...
Personally I prefer Ooznest's V1.0.7 firmware (I think you have to install that before the latest Rep-Rap V3.3 based firmware) - some people have...
Check that your machine is square, especially that the X axis is square to the Y. It sounds as though your emergency stop may have resulted in the...
Something has gone wrong with your firmware set up - that is a configuration file for a 3d printer! Where did you get the machine from, if Ooznest...
Your config-axes.g file should say; ; Axes configuration executed by config.g M584 X0 Y1 Z2 U3 ; Apply drive mapping to axes M584 P3 M906 X2400...
Wiring problems are the commonest cause of the symptoms you describe. To check, disconnect the motor from the leadscrew and connect it to the X...
Norton says this is virus free - haven't bothered installing it as I mainly use Fusion SketchUp Make 2017 Alex.
@DarkPenguin, lower wheels, yes, but you'll also have to detach the nut blocks from the X gantry plates or remove the leadscrew. If I recall...
