Separate names with a comma.
Some features disabled for guests. Register Today.
V1.0.378 will help with the issue, but can't release it at the moment - issues with the certificate authority access, waiting on accounts to help...
Up to about 80degC is normal. If its over that see docs:blackbox-x32:currentadjustment [OpenBuilds Documentation]
Are the holes undersized by 50% too or is it just perhaps the distance between them (stalling during the long travel move?)
Yes, check those. But if its belt, could also be damaged belt (broken reinforcement strands causing stretch), incorrect belt tension (pull to...
Honestly surprised that works (or it won't for long) - USB is super sensitive, shorter cables are better. Usually 30-60cm cable recommended. You...
Correct, once at cut height its time to start cutting! It pierces at 'pierce height'. Wait for 'Pierce Delay'. Thats the "pierce process" after...
CONTROL > Wizards and tools > Calibration
Log output will help tell you whats happening. Does it disconnect with a message like ERROR!: No Response from Controller - See...
$5=0 for NC, $5=7 for NO switches
On a Blackbox : plug and play On a Arduino. No pull ups. But you need to run NPN type, on 6-30v. Then to prevent damaging the arduino, level shift...
Check wire routing, physical seperation of high voltage components, use shielded cable, shield the electronics (our BlackBox has filtered inputs etc)
Does the included drive work? If so Interface is fine. Just grab a standard drive of the shelf and plug it in. Messing about with the formats not...
Check grubscrews on shaft coupler / pulleys Setup surfacing job dimensions keeping endstops in mind. Framing pass will run outside dimensions.
Use troubleshooting tab to switches by hand - before ramming machine into them (: - only reason a switch won't stop the machine is incorrect...
Awesome work! Thank you!
That's why the Endmounts has bearings to constrain and support the leadscrew directly, you don't use the motor's bearings. The motor bearings...
Changing axis count > grblHAL wipes settings on first boot anyway (so even if you don't wipe it during flash, grblHAL itself will reset settings...
Built in was to test if its related to macro, or even commands (we know the menus use the right commands) So more likely wiring or faulty servo...
The the built in Tool On / Off menus, to eliminate issues with the Macro?
Post Processor Editing
