Separate names with a comma.
Some features disabled for guests. Register Today.
Its out of stock everywhere.
Just run another set of signal wires to the iot relay. Here's an example. Just exclude the toggle switch: docs:blackbox:iot-and-laser...
You can add the connectors to the motors you have. They are just screw terminals here: Xtension Connector Sets
3 is all you need. You can enable soft limits in grbl so you wont slam into the ends without them.
I have to agree with Giarc. I started with an xpro, then built my own using DQ542MA drivers then ended up with a blackbox.
I appreciate that. Whats strange is that it sounds terrible on all axis. I didnt see anything strange with your settings. Maybe remove the x...
Sounds like a wiring issue. Double check all your wire ends (screwed down on bare wire not insulation, no traces sorting other wires, etc) Maybe...
Try adjusting the current using the trim pot: docs:blackbox:currentadjustment [OpenBuilds Documentation]
Ahh. Ok.
If you flip it so its in portrait mode, you'll get a bigger simulation area. [ATTACH] You can also set it to launch in full screen (half way...
Did you check the max travel settings like I suggested? You can have 12 foot table and still have that error if those settings arent correct for...
Look at the Alarm 2 error. Your gcode will exceed the machine travel. As programmed, you need 43.0315" in X and 46.1062992" in Y. And this is...
9mm. I have mine set to custom as well. Mine is slightly undersized.
You can change to a "custom probe" in the lower left hand corner of the probe screen. After that, change the plate thickness by clicking on the...
Check the lock collars on the Z axis. Make sure they havent slipped. Mine has a few times.
The code looks fine. From X and Y zero, it should only move 291.519mm in X and 128.878mm in Y. [ATTACH] A few things come to mind: Are you sure...
I vaguely remember issues with the latest grbl on an earlier xpro. An xpro 3 I believe. Peter who is a mod here can answer that better than I....
Its perfectly fine to design in one unit of measurement and post to another. You just have to make sure the post processor you are using spits...
Look at the previous toolpaths and see if you have a machining allowance set on them. If there is than that's your issue. There is more stock...
That's the only toolpath?
