Separate names with a comma.
Some features disabled for guests. Register Today.
I just realized I gave you mm values. For the sake of any newbies finding this thread later, please note that the code posted by CartesianPlain...
Another issue you may run into is your move to Z0. If you are homing with limit switches, then G53 G0 Z0 will hit your switch. Ideally, you want...
You can use drop in nuts or you can drill a hole in the face of one of the slots and put a regular bolt in there. Use a step drill. Its easy.
There's quite a few stl's out in the wild if you have a 3D printer
A few things to check 1 - Did you install the FTDI drivers?: docs:blackbox:install-drivers [OpenBuilds Documentation] 2 - Is usb selective...
Your grbl settings are on the blackbox. They are not in software or the interface so it wont matter what you use to connect. Its going to...
yes
Click on the gcode editor tab and delete it from the code listed. However, you'll probably have more issues since its not grbl compatible gcode....
Sounds like you're missing the probing routines that should be on the usb drive on the interface. Look here: docs:interface:prepare-usb-drive...
Are you homing your machine every time you turn it on? Are you remembering to set your work coordinates (set x, y, z zero). Do the work...
Congrats! There's no machine build docs, just the videos. VFD hookup is in the blackbox docs: docs:blackbox:connect-vfd [OpenBuilds...
Here's the fix: docs:interface:firmware-error-partitions [OpenBuilds Documentation]
Hey Peter, Is the first timestamp in the lower part of the window the job completion time? If so, it doesnt match the completion time in the job...
Hi Rob and welcome. Thank you for the clarification. There's been more posts about Carveco lately here and in the FB group, so glad you cleared...
Inch mode used to be 10". It was recently changed to allow for .001" so 10" got the boot to make room for it. 100mm is not too much when you...
Confirmed by other users here: Carveco Gcode file selection?
Go into grbl settings tab and lower your Y max rate. Its $111
I just tried to recreate your issue and cant. Clearly there's an issue with the workspace you posted, but any and all new toolpaths generate...
Forgot to say that you can set your first cut depth by entering a value in "Cut Depth Start" box. So, if you want to start at 6 and your cut per...
Peter will be able to answer this. But yes, I see the issues. However, if I select your 30mm pocket and add a new operation, it correctly gives...
