Separate names with a comma.
Some features disabled for guests. Register Today.
Maximum roughing step down doenst mean "this is as far as it will go". It means, "this is as far as it will go in a single pass". You have...
Sure. Use a toolpath containment strategy. Google "fusion 360 toolpath containment". Lots of videos and posts on the subject.
Are you sure about your motor pairs? Just a thought.
OH! That's why you were working on it for 29 hours. Great job.
Glad you got it sorted. For the sake of someone stumbling across this post, I assume that first you set $3 so that Z move in the correct...
In the documentation it says to label the pairs as A+A- and B+B-. The blackbox has the labels printed next to each axis. Hard to see in the...
Dont rely on wire colors. Use this guide to ID them: docs:blackbox:faq-identify-motor-coils [OpenBuilds Documentation] Also, check for any...
Then start with the same steps/mm setting. But make sure you also run the calibration wizard to compensate for difference in manufacturing...
It depends on the size of the screw. If you go into the settings, there's a calculator next to the X steps per mn setting. Use that, save, then...
Mine was an atek as well. If you look at their catalog you'll see their Smart-gage option. That's the one I retrofitted. Its stupid expensive...
From what I recall when researching replacement off the shelf systems, all of them used belts. Maybe the multi-axis back gauges used screws. Not...
It is. There's a lot of lost time and added motion having to pick up and put down the same part multiple times. All that was needed was a limit...
Does it only happen when cutting?
Here you go: docs:interface:connect-generic [OpenBuilds Documentation]
I made one but used a different approach. Mine was a 4 foot (maybe 6 foot, cant remember) wide break. The original auto back gauge took a dump...
If you look at the upper left part of the screen you will see that its CNCjs
Not exactly. Check out this thread from yesterday for solutions: XYZ Probe use on different corner than lower left
I had that thought once. But then I realized that my expectation for what its used for was wrong. If you understand that it will show you the...
Havent heard of that one yet. The difference in board numbers isnt a concern. They are the version of the actual board and not of the blackbox...
Hey peter. What does "[unable to check]" mean for firmware? No wifi connection?
