Separate names with a comma.
Some features disabled for guests. Register Today.
You don't really need lots of air or high pressure - the main aim is to clear the chips away - most of the heat generated goes with the chips. Alex.
WD40 is also inflammable - I find a blast of air is an adequate coolant now (and safer) [ATTACH] Alex.
As @Peter Van Der Walt said - caution with alcohol - I don't find I need it now, but when I used it I used tiny amounts which evaporated almost...
I quoted my speeds and feeds above - with linear rails, 3 mm single flute spiral upcut, 13 K rpm, 2000 mm/min, 0.5 mm doc/woc. At 0.5 mm doc...
Hmm, I use uncoatd bits for aluminium - cheap 3mm single flute, spiral upcut from Ebay. RoutER11 at 13K rpm, 0.5 mm doc/woc (I'm sure I could...
If you get an error again, get a screenshot of the error message and the serial console. Alex.
Error 9 on it's own doesn't tell us what the issue is - there is usually more detail. Do you know exactly what the error message said? Or what the...
What controller/control software are you using? The principles are in the document attached, but if you are using Openbuilds control it has a...
I'm not sure about defining the pin in the Rep-Rap V3.3 based firmware either @Benjamin Vg - I'm still using the Rep-Rap V2.05 based firmware, but...
I am certainly not expert on this @Benjamin Vg, but a quick read of the Duet g-code wiki suggests a bit more research is needed; M453 - enable cnc...
Sorry I can't help with your grbl panel problem, but have you tried a different control programme such as Openbuilds Control?...
[ATTACH] It says "Error 2 - G-code motion target exceeds maximum machine travel", unfortunately grbl doesn't tell you which axis this error...
That speeds and feeds table was created by the people at Carbide - I just did the metric conversion. It is for a 1/4"/6.35mm bit, but they don't...
If you turn your stepper motors by hand, PLEASE make sure the power is off AND they are then disconnected from the controller. The motors act as...
@Ciaran Burns you would be amazed how often that comes up. Think about relocating the Z homing switch to the side of the Z C-beam and actuating it...
Duet controller. Check the wiring to your Z homing switch, especially where it comes through the hole in the X gantry plate. Alex.
First can you tell us what controller you use with your workbee? Alex.
@JovP did you definitely do step 4 of the guide we linked to? Ground of pwm module to ground of the Duet's power supply? Alex.
If you search the forum for "solidworks" you will see that this has come up several times (including the link below), several posts have links to...
I spent a lot of time a year or so ago looking for a solidworks post for grbl for someone and only found the one above. Quite a few people move...
