Separate names with a comma.
Some features disabled for guests. Register Today.
You presumably have hard limits enabled, in which case that is normal behaviour - if a limit switch is triggered the blackbox will go into alarm...
As I said above, set $27=10. If that fixes it you can try reducing it until the problem recurs, then increase it slightly again. Alex.
Increasing your pull off distance might solve this issue. What is your $27 value? If it's less than 10 try setting $27 to 10 and see if that fixes...
If so your X and Y axes are reversed - X+ should be to the right, not to the left and Y+ should move (the bit) to the back, not to the front. Alex.
Not quite - when you turn on grbl will set the MACHINE co-ordinates for X, Y and Z to zero wherever your machine happens to be. Your jobs are done...
Thrust Bearing Alex.
Your leadscrews will vibrate, and that will be absorbed by the bearing - it's like hitting the bearing with a very small hammer hundreds of times...
Yes, you are presumably using the Openbuilds post processor. Always home the machine when you switch on - do you have limit switches installed and...
Do you have a grbl controller - if so that code would be correct if you set (MACHINE CO-ORDINATES) Z home to zero at the top of its travel. G53 G0...
That's not the grbl post processor for FreeCad. I don't use FreeCad, but I believe this is the grbl post processor for it;- FreeCAD/grbl_post.py...
If it's a cribbage board it may just be too big a file for Openbuilds Control's 3d viewer. Alex.
@Todd Hoffert, please do post your Vectric file here as well as the g-code - we can have a look at it in the trial version of Aspire. Alex.
The same as the acceleration setting for X and Y - $122=150. Alex.
Yes- these are needle roller bearings - much greater surface area than the very cheap ball bearings used in the original. Of course, if the...
The thrust bearings Ooznest are using are not really up to the job - if the bearing proves to be the issue look here:- AXK0821/AS0821 Budget...
This might help with the dust hose issue :- Swing Arm Re the squeaking - have you lubricated (dry ptfe or silicone spray ONLY - no oil) your...
Error 25 is sometimes caused by data corruption between your PC and the controller (the end of one line or the beginning of the next gets lost...
No, you will have to home the machine (its the only way it can establish a reference point), but you shouldn't have to reset the workplace zero. Alex.
Shine a light on the cutting edge - if you see a bright line the bit is blunt. Alex.
That's not a good post processor for the Duet. Birthday tomorrow, and hospital Friday, so will try to find time over the weekend. Download team...
