Separate names with a comma.
Some features disabled for guests. Register Today.
Get some roller stands, cut the first half of the sheet, slide it through and cut the second half . Seriously, there's a limit to how long you can...
What machine are you using that controller with? And especially, what are the specs of your stepper motors? That is not a very good controller for...
Afraid I can't do much this evening (cooking my wife's birthday cake). What times are you available (I'm also UK based). I would still like to see...
It sounds as though you might have a short circuit somewhere. Try disconnecting everything from the blackbox and then see if it will power up. Alex.
You do seem to have some connection problems - is this the WiFi version of the Duet? Have you set it up to connect via your lan or as an access...
PS - if you do have the Duet can you tell us what version of the firmware you are using? There are significant differences between the latest...
Your mention of the SD card suggests to me that you are using a Duet or possibly XproV5 controller - could you give us more details of your...
Yes you can - the "error" message you were getting was just telling you that you hadn't selected a wcs in Fusion cam, and it was going to use the...
Thanks @David the swarfer, @Peter Van Der Walt -have passed that on. Alex. As David and Peter predicted, the OP has just confirmed that laser...
No, haven't looked at the g-code file yet - was my bedtime when this came up last night. I suspect the issue was the need to delete the OB post to...
Thanks for that - I'll pass that on . Alex.
I'm getting reports that Vectric are saying that the OB post processor for Vectric software (specifically Vcarve) V11 is not supported and that...
No, they are stepper motors - the two Y motors both receive the same instructions to move the same number of steps . If they move a different...
You only need to reset Z zero when you change tool. X and Y are set at the centre of the bit, so changing to a different diameter bit doesn't...
Nothing wrong with your Vcarve toolpath that I can see - the only thing I can think of is that you didn't set the Z zero correctly for the 1/16th...
Posting your Vcarve file would be the easiest way to let us see what you have done. Alex. PS what version of Vcarve pro?
I actually meant, with the power off, disconnect the motor wiring from the controller - the motors act as generators when turned by hand, creating...
Check that your machine is square. Start by measuring the diagonals of the frame - they should be within +/- 1 mm of each other. Then, with the Y...
Certainly not impossible, but not ideal for 3d printing - feedrate and accelerations would be rather low compared to a 3d printer. You would...
Also, if you search the forum (magnifying glass icon top of the page) for "feeds and speeds" you will find quite a few resources. Alex.
