Separate names with a comma.
Some features disabled for guests. Register Today.
I surface my spoilboard with a MAX depth of cut at 0.5 mm - no point throwing spoilboard away unless you need to. I have a workbee rather than a...
Have a look at the section headed "Troubleshooting", @Tony Rebelo . Alex.
Did you check your wiring with a meter? I ask because your symptoms are exactly what you could expect if one wire to the X stepper was only making...
I can't see anything wrong with your homing settings - seek and feed rate seem OK to me. I don't use OB control myself, however, so you will...
Post your grbl settings here so we can see if there's an issue with any of them. Alex.
Won't be any duty - below the threshold - just VAT at 20% and you don't always get charged that on small value items. Ratrig in Portugal and...
Had mine a while - it's less than half the noise level of the (Chinese clone) Makita I had before. Alex.
Correct me if I'm wrong @sharmstr, but couldn't you just probe X and Y in the desired position (@Aeneas wants to create a fixed G55 XY zero...
No - just use Openbuild Control to send G55 to change to that wcs, set your workplace zero exactly as you normally would. Grbl will remember that...
Easy then - just choose the wcs you want to use for a particular job in Fusion cam setup. [ATTACH]
Yes - you have multiple Work Co-ordinate Systems. Can't remember how many grbl allows you, but the first (and default one) is G54. You could use...
I'm very familiar with the Duet 2 controller (not so much with the RRF3 based firmware from Ooznest if you have a Workbee Z1 +, but I know people...
Wasn't my post - just trying to be helpful. Alex.
For 1000 Watt, ER16 collet, speed set manually or by 0-10 volt signal, 355 euros from sorotec. Mafell FM1000 PV-ER 16 Alex.
Will try, but we have visitors this evening - may have to wait until tomorrow. Alex.
A good test for backlash is, using the same centre point, two squares at 45° to each other and a circle of the same diameter as the sides of the...
2~3 mm doc is a bit much for surfacing the spoilboard - I never do more than 0.5 mm/pass - you'll be throwing the spoilboard away before you get...
Looks as though you didn't get the Z zero quite right when you changed bits, and you may have some play in your Z and X gantries. What was your...
Check the wiring to the stepper motor that is misbehaving - this fault is nearly always a wiring problem. This guide might help ;-...
See above, Z axis slowly dropping Alex.
