Separate names with a comma.
Some features disabled for guests. Register Today.
This one is way more complicated than anything I have done in Fusion @eric weatherman. Your fretboard is in the design, but not in the cam for...
Still comparing the simulation with the g-code. The first thing I notice is that you have 1/8" of stock above the model, and the g-code seems to...
Please share your Fusion file and the g-code file so that we can see what is happening. Alex.
Have you checked the wiring with a meter? You could have a broken wire inside the insulation where you can't see ir. Alex.
Well worth earthing the vac hose - just some bare copper wire along the inside and connected to mains earth at the vac end. Alex.
Did you check that you didn't tick the "stock to leave" box in Fusion cam? I've made this mistake before because I have to scroll down to see it....
Spindle on/off delay seems to still be there - it's in your screenshot. Alex.
Yes, bearings were high on my suspect list. Alex.
Do disconnect the motor from the controller if you are turning it by hand (or disconnect the motor from the leadscrew). As to why its harder to...
Also look for anything that might be causing your leadscrew to be misaligned (nut blocks vibrated loose, damaged bearing etc). I have similar...
The joys of parametric design - do one and the next variation only takes a few seconds. Alex.
Alex Chambers submitted a new resource: V-slot clip - Clip to hold thin materials to V-slot I've just upgraded my workbee with linear rails,...
I've just upgraded my workbee with linear rails, taller Y gantry plates (courtesy of a gift of an upgrade kit from CNC3d) and taller Y end plates...
Nicely done! But you have hidden lots of that beautiful framing. I'm building a cotton mill for a model railway based in Yorkshire UK, and I have...
@bryan robbins, according to the message from Ooznest they think that you have the Xpro V3 controller. That uses standard grbl so @Peter Van Der...
It is still most likely that the wiring is picking up the emi - the lead from the vfd to your spindle is the main source and physical distance the...
Keys board for my younger son who is a keen biker. Line drawing of a Honda Valkyrie (he owns one) from the internet, engraving toolpath - 1.0 mm...
Bigger isn't necessarily better - depends on the level of accuracy you need. As the machines get bigger rigidity becomes more of an issue. 1000 mm...
Hmm, I gave that advice because Autodesk say Fusion exports dxf's as R14 - don't use it myself because, as @Peter Van Der Walt says, Fusion cam is...
Yes - you can save a sketch as a dxf file from Fusion (even in the personal use licence version) [ATTACH] Spark Concepts wiki, in case that is...
