Separate names with a comma.
Some features disabled for guests. Register Today.
As a test, run the same files from the PC for a bit, EMI is a little more likely to affect Interface (long cable, better antenna) so that might...
OK, not seeing anything wired incorrectly. Laser: BlackBox 4X used a 4-pin connector, you have a 2-pin on there now. Sure it was never...
Either the gcode really contains invalid gcode (post file for review) Or it could be corruption caused by EMI: docs:blackbox-x32:faq-emi...
Use Snipping Tool to capture screenshots - Microsoft Support would make for a much more readable screenshot that a photo of the LCD
I don't use the WebUI myself much (we prefer CONTROL) but perhaps they just hide the password for security reasons? If you aren't using CONTROL,...
Define " loses the WIFI configuration " - its stored in EEPROM, it can't really be lost. You might sometimes fail to connect (Settings still...
Exactly the main concern. Focus efforts on finding cause. Otherwise a brand new X32 may go up in smoke with no chance of warranty once connected...
If its not in working order it can't boot Well, then perhaps the Arduino is dead because you aren't powering it anymore? Not really sure without...
4X flashing currently broken, see OpenBuilds-CONTROL/CHANGELOG.txt at 7a0cbe49c650b61fc5aed45d8c52796968a22c37 ยท OpenBuilds/OpenBuilds-CONTROL...
Not likely. As you see testing another PC doesn't help either
Firmware doesn't just dissappear. Flashing is possible (Wizard and tools menu). But that might be like trying to change the oil on a vehicle...
VIN is the other side of the on board regulator so you probably damaged the Arduino. Replace it
Need to see both ends of things like limits wiring etc. Something caused a short, would need to find what it is.
English only please. See section 15 of Terms of Service and Rules | OpenBuilds Your Vectors needs to be Closed docs:software:file-errors...
Old version of post in a new version of Fusion. Use the latest Post docs:software:fusion360 [OpenBuilds Documentation]
Could be a couple things 1) Gcode for review 2) Check that leadscrew is still tensioned (no axial play between leadscrew and endplates) 3) Check...
That indicates a serious short circuit. Awaiting pictures, but that symptom already tells us there is some short circuits in your setup...
Did you remember to HOME? (previous successes might have been pure luck that Z was high enough on reset. But really best to actually Home)
Heavier gantry, heavier machine = even lower acceleration Low mass = less enertia = better acceleration. Physics is sadly a real thing that...
