Separate names with a comma.
Some features disabled for guests. Register Today.
Missing the PSU pictures. Noting 2-wire limits so pictures of limit switch side wiring too please. Noting a Laser driver above the BlackBox so...
Not too extreme, our stock profiles are conservative to get people going, reliable and safe. But definate scope for plenty of tuning. Motors...
Correct, BlackBox X32 was a evolution of the BlackBox 4X that ran Grbl. From that legacy we kept the single PWM pin > 0-10v converter method In...
Please post pictures of all wiring, PSU etc for review
That in itself will make a speed difference - Less enertia than the bigger frame likely. F still honors Max Rate. Read the sections linked above.
Could do it in gcode. Most folks just add a Macro button to click between jobs though. Keeping it simpler Most people just use their built in...
Grbl v1.1 Configuration CoreXY/H-Bot. But how big? Also a 2*2m? Stock profile does err on the side of conservative so also see Grbl v1.1...
https://openbuilds.com/uploadfiles/Part%20Specs/OpenBuilds%C2%AE%20Actuator%20Tests_V2.pdf along with OpenBuilds Actuator Test Rig should give you...
Grbl really only has one tool output. You will need to do - Change $32 between router and laser jobs - Change which is active (easiest way is...
Does do that: Setup: docs:blackbox-x32:wifi_setup [OpenBuilds Documentation] Connect: Scan and select IP from dropdown. Uses Telnet backend...
One possibility is just plain power requirements. Motion system will be using a couple kilowatt too, on a heavy steel machine like that. A single...
See docs:blackbox-x32:connect-door-sensor [OpenBuilds Documentation] - BlackBox X32 Docs are a good read too (: Belt might be able to go a little...
There should be reviews online somewhere :) but I can't point you at any off the cuff, we don't really do the influencer thing so whatever is out...
The OX is quite an old design from the early OpenBuilds days. Belt driven, relatively flimsy, needs custom plates etc. No longer relevant except...
Negative: 4th bullet point of Grbl v1.1 Commands (That Grbl wiki sure is a must read) The Safety Door feature does stop tool and coolant though...
Is in Seconds. G-Codes Use a Grbl compatible CAM application there are lots. See docs:software:overview [OpenBuilds Documentation] What CAM are...
Best to use Grbl compatible gcode yes.
Correct, you may feel like the machine does "nothing" while moving the nonexistant Z but you'll see the DRO numbers updating as a reminder. Use a...
Second one, but I would not switch GND. Leave it connected (safer all round than floating grounds and alternative ground paths). Just...
As far as you got, probably not much else that might be missed. But do peruse start [OpenBuilds Documentation] a little, lots of good info in...
