Separate names with a comma.
Some features disabled for guests. Register Today.
OK - just checked with the Duet g-code wiki (Gcode dictionary) - you can set negative values for the axes minima, but to emphasise a few points...
I believe you can use negative values in the axes minima settings in config.g (I'd recommend making changes by copying the lines into...
It's only post processors that use a G53 Z retract that cause any issues - workplace coordinates are exactly the same as normal, so, for example,...
@James Boulton - I assume you are using SketchUcam? Not something I'm familiar with but can you confirm that you have a fairly standard set up...
I've got used to it. Been busy lately (setting up a new Facebook group for Workbee users) but I'll have a look at the Rep-Rap wiki later to work...
See pic - it's in the heights tab. Alex.[ATTACH]
What cad/cam and post processor are you using? Alex.
The correct post processor should do that for you. Alex.
It shouldn't make a difference with the Vectric post processors based on the grbl ones - they correctly convert units and put the right g-code...
As @sharmstr said, unless you have the 230 V version, in which case it is ;- 0,13000,17000, 22000, 29000, 31000, 33000 Alex.
What controller are you using? Are you homing the machine on power on? It's actually G53 G0 Z-10 - ie; MACHINE co-ordinates, 10 mm below the home...
As @Peter Van Der Walt said, also have you calibrated your machines steps/mm? Alex.
Follow the help tab in Vectric to find instructions on editing post processors. Alex.
As that says, it's not an error - you didn't select which work co-ordinate system to use in Fusion cam setup, so it is going to use the default -...
Wrap some tape around them. Alex.
To measure diagonals I use two pointed sticks - each over 1/2 the distance. Push the point of each stick into opposite corners, hold the sticks...
Dust collector could well be part of the problem - have you earthed the extractor hose? If not run a length of bare copper wire along the inside...
The changes you need to make are in Vectric when you start creating a toolpath. Not at my PC, so can't give you a screenshot, but at the bottom of...
That might be a clue - have you got a connection between mains EARTH and DC GROUND? There shouldn't be any connection between your metal framework...
Have you set $4 =1? Alex.
