Separate names with a comma.
Some features disabled for guests. Register Today.
You haven't shown the ends of your workbee, so I can't be certain but I think you have your spoilboard at the highest position. You certainly...
Many thanks - obviously not big enough for me to spot!!!:oops: Alex.
Can someone tell me how to replace a file in a resource with an updated one? Many thanks Alex.
If you now have the nut blocks loose then they are not correcting for backlash, and are probably introducing some. Watch your leadscrew carefully...
Alex Chambers submitted a new resource: Fusion 360/Duet post processor - Post Processor for Fusion 360/Duet that restores rapid moves After even...
The file with (I believe) all bugs ironed out is now available After even more help from David I think any bugs affecting functionality have been...
Again - checking the obvious - is jogging moving in the correct direction - X+ = right, Y+ = back and Z+ = up?
Do NOT turn your stepper motors by hand if they are connected to the controller - back emf from the stepper motor can damage your stepper drivers....
Maybe stupid question, but you didn't mention it so I'll ask... did you set the workplace coordinates zero? Alex.
Loose drive pulley found so far. Alex.
Blue (non-permanent) loctite is the solution for the drive pulleys on a belt drive. Re dust shoe you could always make one - search the forum for...
Is this a soft limits alarm? - if so check that the safe height (clearance height) you set in your cam software isn't too high, and that you have...
Continuing support from Facebook group - as @Peter Van Der Walt said. If that's not the issue try adjusting the motor current ;-...
What materials do you want to work with? And what sort of jobs? For wood I recommend some cheap (because you WILL break some at first) router bits...
Yes, all grbl users, because Autodesk added a comment to post processors that is too long for grbl. @David the swarfer has re-written the...
Discussion and @David the swarfer's solution here:- Life After Fusion 360
Very nice! For really fine detail try a tapered ball nose bit. Alex.
Actually lower speed is more useful than high speed. In over 50 years of using routers I have never found a use for the top speed of any router. I...
I wasn't using M6 - inserted macro calls to allow tool change and Z probing. I guess I could add the macro s to the end of every file and then...
Don't know how this will affect the swarfer processor, but I can no longer post process more than one tool, so that's hours of work down the drain...