Separate names with a comma.
Some features disabled for guests. Register Today.
The OB light ring is 24V so it gets wired to your power supply, not the BB. Yes, you can run switches on both sides. Just wire them parallel....
You need to adjust your motors steps per mm. If you're using OpenBuilds Control, then use the calibration wizards in the Wizards and Tools menu....
[MEDIA]
Sounds good to me.
Ahhhhh. I didnt catch that :)
There were two issues. One, you were trying to machine outside the boundaries of your work area. That's solved. The next one is that your limit...
It will warn you when it gets to that command. It doesnt scan all of your code for possible errors before you start. The check size button would...
Sorry, dont understand the point you're trying to make. Can you clarify? In any case, take Y for example. You're trying to go to -729. But you...
You didnt say where you set Work 0. But lets assume that you set it right after your homing routine. You have to remember that there is a pull...
Yes. If after you do so the motor turns the wrong way you just need to invert the step direction for that axis. You can do that in OB Control by...
Go into the Wizards and Tools menu. There's a calibration tool for each axis
Make sure your controllers power supply is plugged into a wall socket (dont use the IOT relay to power it). Then make sure your router is plugged...
Not necessarily. Two things to check 1 - With your current settings, is the Y switch being touched at all? If so, increase the pull off. Just...
When the homing cycle runs, it will move to find your limit switches. When it finds them, it will move off the switch (the pull off distance) so...
Very cool!
Awesome!
Going to machine 0 I would expect that it would hit the switch. The reason why there are pull off values for homing is so that the spindle isnt...
When you home the machine, you are setting machine 0,0,0 but your spindle is NOT at 0,0,0 or even 5,5,5. Machine 0,0,0 is always in the upper...
I sent that after he had the issue. That's why I sent it.
You might also want to watch this video starting at about the hour and 5 min mark. [MEDIA]