Separate names with a comma.
Some features disabled for guests. Register Today.
Someone on the FB forum noticed the modified workbee that Heliogen is using. If you havent heard of them, they are a Bill Gates backed solar...
They will power them. I'm running a mix of motors on mine just fine.
It most certainly sets Z. The last line does it. When you create the macro, you have to adjust those values using your plate thickness for Z and...
Then take the Z probe lines out of it. If you read the docs in the link I sent you, it explains each line of the macro.
Yup
Buy a BlackBox :) BlackBox Motion Control System
The ! on save to firmware means changes were made in the grbl settings but they havent been applied to the controller board yet.
What's the error?
No need to change.
Along with Alex has suggested, decrease your step-over. 50% of the bit diameter or less is better than the 80% that you have it set to now.
David explains it here: OpenBuilds CONTROL Software
Hard to tell in the video, but is your homing switch on the right side of your X gantry? If so, you need to take pull off distance into...
Watch some of the openbuilds assembly videos. You'll see how they attach to the x and y gantries. I would advise against putting your router...
Hard limits are limit switches. So you're saying your limit switches aren't working? Have you gone into the troubleshooting tab to test them?
I'm guessing by the description you mean tool length. No it doesn't. But just go to Z0, then move up whatever distance you are off by, then zero...
I have a 20x20 extrusion bolted to the X gantry plate. Here's an old pic when I had a piece of wood instead [IMG]
Use drag chains: Drag Chain Cable Carrier
The controller is an xPro (Spark-Concepts/xPRO). Looks like it might be version 3. Use OpenBuilds Control to connect to it: OpenBuilds Software...
No, that's not what he is telling you. Assuming you are using a BlackBox, when it starts up, GRBL will default to mm. Even if you change the...
Its an alarm state (i.e. limit switch triggered), not a G code error. Most likely cause is EMI.