Separate names with a comma.
Some features disabled for guests. Register Today.
Ahh - I remember Novell - a whole shelf in the bookcase for the manual! :confused: Alex.
Check your Z clearance height in your cam software - what are you using for that? Alex.
That is just telling you that you didn't choose a work co-ordinate system in setup in Fusion (post process in manufacture setup) - it will use the...
We get amazon too (and an incompetent government) Alex
What happens if you set $3=1(invert X direction) - does the X jog + but not -? Alex. EDIT - should have said check what $3 is first. Check out...
I strongly recommend cleaning the oil off and using a dry lubricant such as ptfe or silicone spray. Dust will stick to the oil and cause a similar...
Was the stepper motor wiring done by you or supplied by Ooznest? If the latter check the crimp connectors - I have had crimps broken within the...
I can't help much with the belt tension problem, but please be aware that if you move the axis around by hand with the motors connected to your...
Sorry, I don't use OB control, @Peter Van Der Walt is the expert to answer that. Alex.
What size steps were you jogging in? Soft limits will give you an alarm at the beginning of a command that would take you past the limit. Alex.
Have you checked for play in;- Router/spindle bearings Z axis Twisting of X axis? Alex.
Depends on your grbl settings, if you have $1=255 the motors will be powered when idle. Alex.
This is what I meant - a picture of a problem someone else had with a SPAM workbee;- [ATTACH]
In addition to @Giarc 's comments (drivers are the most likely cause), look down on the Y gantries - is the leadscrew parallel to the gantry...
Is it possible to drill out and re-thread larger? Alex.
Just to add to Joe's comments. You need to be clear about the difference between ground (usually refers to the dc ground of your control circuits)...
Have fun! And yes, this is the place to ask questions. Alex.
I usually use (blue) masking tape and superglue, but recently I used cam clamps on the sides of a scrap of mdf to trial run a 3d carve. Did the...
Yes. The Xtension limit switches are normally open - wire them in parallel. Alex.
You stand up when coding @Peter Van Der Walt? :ROFL::ROFL:
