Separate names with a comma.
Some features disabled for guests. Register Today.
As Marconi discovered, an arc (spark) emits radio frequencies. Alex.
You would be asking a lot of the standard motors if you wanted them to raise the whole X axis as well as the Z. I asked Ooznest this question when...
How did you identify which wires were connected to the stepper motor coils @Xamer ? This thread might help with the wiring; Stepper motors won't...
As @Giarc said, also have a look here; Stepper motors won't turn Alex.
Are you connecting your stepper motor directly to the Arduino? - that won't work. If you are using a stepper driver which one, and do you know the...
Hi @Colin Hart , when I calibrate my machine I use the pointiest tool I have. I don't actually cut - I have the tool about 1mm above the...
Hi @Colin Hart , I don't follow your spreadsheet. In cut 1 did you have steps/mm at 400 and get the result shown? Then in cut 2 did you have...
Increase $27 to (say) 10 to see if that helps. If it does decrease it until you get to a value that reliably works. Alex. Also if you set $20=1...
PS, @Mark Bullock , your design may not have any curves, but your g-code may still contain arc commands (G2/G3) as your toolpath may include a...
No, you didn't change anything in the Duet firmware to enable grbl. It's all g-code, but comes in different "flavours" - basically a selection or...
What post processor are you using? You should be using this one; https://ooznest.co.uk/wp-content/uploads/2019/02/Fusion-v1.0.1.zip Alex.
Yes they do - like anything to do with Fusion there is a learning curve, but I mostly use Fusion and like it because (for the simple jobs I do) I...
I can't help with the Open builds cam question, but why are you not using the cam functions (manufacturing) of Fusion? Alex. PS that was a...
Another common problem is "my steppers keep reversing direction, or just sit there making a noise" This is almost certainly (99.5% sure) one of...
We will need more info to help @Johnopc21. What controller (electronics) are you using? What software do you use to send your code to the machine?...
You didn't say what version of the Duet you have, but people with the WiFi version are controlling their Duet with all sorts of devices. How is...
Not sure what the problem is @Handlebar , but once you have set up the Duet any browser can access it if you type the address into it. The Duet...
:) Thanks for letting us know what the problem was - useful for anyone else making the same mistake! Alex:thumbsup:
If you look at 5:12 on the video the bearings do seem to be flush with the outside of the wheel. Alex.
No, I'm not sure - I don't have a belt drive machine, but looking at your pic it looks as though there is more space below the wheel than I would...
