Separate names with a comma.
Some features disabled for guests. Register Today.
Also please the Fusion file Use File > Export to export a Fusion Archive (.f3d /.f3z) to the local drive.
The post your Fusion360 file and Gcode export for review. Probably something set incorrectly in your toolpaths (:
Does the hello world run fine (to rule out CAM setup vs machine setup) docs:blackbox-4x:hello-world [OpenBuilds Documentation]
S24000 in gcode and $30=24000 = 100% PWM = 10v out the 0-10v S12500 in gcode and $30=24000 = 52.1% PWM = 5.2v out the 0-10v etc S12500 in gcode...
$5=0 if they are all NC
Just takes 3 things. Set $30 to whatever your spindles actual max RPM is Set tool rpm in your Toolpath Make sure to use our Fusion post....
ER11 Collets. Less runout. More choice in shaft diameters. Cheaper than replacement Makita collets (need to go with expensive 3rd party collets...
There are no updates available for it (note the tabs in the flashing wizard. Only X32 and Interface) Grbl is by now retired so no new versions of...
I think so far only this one Getting started with Javascript Macros in CONTROL / Library of Macros created by the community that you will need to...
Checkout the Plasma Readme OpenBuilds-Fusion360-Postprocessor/README-plasma.md at master ยท OpenBuilds/OpenBuilds-Fusion360-Postprocessor
Yes Or just start to CAM in the far more standard and convenient way of bottom left corner origin (:
1) restore last working backup or if you forgot to backup 2) load stock profile from CONTROL > Grbl Settings tab > Select Machine from the list >...
AC EARTH to DC GND short somewhere. Two prong plug on mains side? Try turning it around (live/neutral reversal) or it might be a leak inside the...
Look at the device itself. Is it the old 4X or the new X32 [ATTACH]
Highly unlikely to be related Far more likely a loose setscrew on the shaft coupler or some other mechanical slip if its just slightly lagging....
Exactly so something odd happened. It should still do what it always did. Clean your startup items and try again. V1.0.370 to now was a major...
The Grbl Wiki described the process. But go for half current value now, see if it helps first. Get the patient stable first (: then retune for how...
Make sure you aren't overtensioned. Its just to prevent sag. If its needing excessive tension not to whip like crazy the leadscrew might be bent...
I am referring to this attempt to mix them. Ours have always been the same thread, so whatever doesn't fit comes from a different vendor. Count...
Leadscrews squeeking, try some Dry/PTFE lubricant (not oil). That will lower the friction a lot. Try lowering Acceleration rate on Y to half...