Separate names with a comma.
Some features disabled for guests. Register Today.
That'll be the custom macros referenced above. Everything else relies on our probe... So maybe just get ours? XYZ Touch Probe Plus
Are you using the Probe menu? As shown in docs:interface:usage-probe [OpenBuilds Documentation] Did you edit the Probe file by any chance?
OpenBuildsCAM (Free) is a 2.5D CAM only Use Vectric or Fusion for 3D (STL) work. Have a read through the documentation docs:software:overview...
All day? The battery (kwh) will be the more expensive concern (say 100-300wh for the machine and a laptop. x 8hrs = 2400wh capacity * 65%...
Straight is probably still doing the same (closing start and endpoints for you) thus running start to end and back to start again. Being a...
Either incorrect value on $30 (1000?) or $33 (5000 default but cheapie laser modules might prefer lower like 1000hz) Steps per mm first. (Speed...
OpenBuildsCAM (and some others) needs Closed Vectors. See docs:software:file-errors [OpenBuilds Documentation] That 2 is an Open Vector. If...
That's fine. As 0-3v would be ignored. They all do that and it's not an issue if the VFD properly set up. The PWM to 0-10v section is an old...
VFD Spindle Control via OpenBuilds BlackBox Controller and Software says its not PD011 either Just guessing off your PDF here - really best to ask...
PD010 doesn't look like the usual one. Should be in freq not voltage. Maybe PD011 (could try 120hz and see if it does as expected, if not revert...
That's a VFD config - something similar to Min Freq (set to 120Hz) You want the VFD to ignore 0-3v (0-7200rpm) and only start up from 7200-24000...
OK so I downloaded a fresh trial and its 1.5.06 [ATTACH] so might be that you are just running outdated versions? Public Beta Releases - 1.4.04...
Catch up by flashing via CONTROL: Follow sections 3.1 and 3.2 of the Interface Documentation docs:interface:firmware-update [OpenBuilds...
Also try playing with the DTR checkbox (try with and without) Device Settings - LightBurn Documentation You are on 115200 baud rate? Did use the...
Sorry then its a LightBurn specific issue. Not seen that before either. Try their support page Contact / Suggestions
Double check its still working in CONTROL, as that sounds almost like $4 Invert Enable is set incorrectly - should be $4=0 To move motors you...
Yes, Tool On looks at the Grbl Settings Do a EEPROM reset [ATTACH] Then try again Import the backup from the Restore Backup button [ATTACH]...
But Where do you get the error? Tool On Menu? From a Job? Etc (see my earlier reply) Yes you should: [ATTACH]
Thank you. We note you already have an open ticket with the store about this. Please continue with the store to ensure we provide you with the...
Or while doing the first Z+ moves, perhaps hitting the Z axis hard stop and losing position? (Heights set too high?)