Separate names with a comma.
Some features disabled for guests. Register Today.
So back to Wednesday's question :) If not, does your plasma have a 2T/4T switch on the front (try other position)
Interesting. You wouldn't happen to have a non-working backup (off the X32, post migration but not working) we can compare against your current...
Noise sounds like you have Max Rate set too high (causing the stall), maybe acceleration a bit low took a while to ramp up
SolidWorks CAM with BlackBox/GRBL1.1 lists a couple Grbl compatible post processors
Same question from me: 1) machine profile loaded (So jogging 10mm moves 10mm?) and also more importantly: 2) remembered to SetZero before...
Thanks, tagging in @David the swarfer for the fusion questions (:
Fixed, see "An unknown error occured:TypeError: Cannot read properties of undefined (reading 'indexOf')" · Issue #102 · OpenBuilds/OpenBuilds-CAM...
Can't help until you provide the Project file as requested Everything tests fine here, so you'll need to provide a Project Export [ATTACH] So we...
Read above, you replied in the wrong post but I merged the threads, just scroll up you might not have seen my reply Grbl profile? New 4th in...
371 is the latest. The older version was 370 - back in June 2023 from which you should update to 1.0.371 Releases ·...
Tag us on Instagram, Facebook or post about it here on the forum, we always love seeing projects
I see a lot of low voltage cabling right past a noisy (electomagnetic radiation wise) VFD VFDs also need good shielded cable, proper earthing...
Ok that's actually good then probably just EMI, not a short
The startup message indicates the controller rebooted. Usually caused by wiring shorts (shorting V+ to GND for example, voltage rail drops too...
Thank you!!!!!!!!!!
Would you consider downloading and posting them as a Resource with a nice short writeup? Resources | OpenBuilds Just in case the original site...
Don't forget to post No, the M5 in the GCODE should Which is why we asked
Could take them out, lay them side by side and see if the helixes line up - might be rolled out of spec (replacements needed)
Most likely something mechanical. Loose setscrews on shaft coupler, loose stop collar, etc Perhaps one side binds a little, or stalls. OpenBuilds...
