Separate names with a comma.
Some features disabled for guests. Register Today.
As Alex said, if you are in the USA, you should really consider buying from OpenBuilds. You didnt say what size you wanted. If you want the 1010...
NEMA is a standard one of which is a dimensional standard. So all NEMA 23 have the same mounting. The only thing that changes is the length....
Thanks, Mary!
Is there any way to add an anchor in the builds? I'm constantly telling people to go to my build and "look half way down the page". Would be...
The blackbox has a place to install a probe. The type of probing is handled in software. If you're using OB Control there is a built in Z probe....
Adjust each individually.
There are trim pots on the side of the black box. One for each axis. They control how much current goes to the motor. Not enough and your motor...
nm. I was reading it wrong. I thought you were using G28 commands and that those jog lines were happening during the probe routine. :oops:
I had just changed bits between jobs, so no. For my own education, what are all the $J=G9121X-10F4978 that are issued after I pressed the probe...
One thing to note as well is that the Blackbox has better drivers than the xpro (not sure about the duet). So if you want to upgrade to high...
If it were me, I'd go with either the Blackbox or the Duet. Both are available at Ooznest. I've never used the Duet, but that's what Ooznest is...
Voltage is controlled by M3 Sxxx. See doc: OpenBuilds BlackBox 4X Documentation Here's some links: BlackBox BlackBox
Understand. But my gcode files are in mm. The Fusion post I use doesnt use imperial at all. It will error out if you try to. If you look at my...
Would it be possible to add a cancel or way to close the new pen modal that pops up when you mistakenly press the new buttons that are next to the...
I know. I was just joking around.
Hmmmm, where have I heard that before? LOL
Correct. Doesnt a 110v VFD use AC? So using a blackbox wouldnt be any different. Even us that use a hand held router have two power sources....
You can remove VFD and water cooler from your power requirements. The BB is only going to power the onboard drivers. It will send low voltage...
I do something similar and use a torque wrench since the length can vary depending how tight the collet nut is.
I think I need to change the build from in progress to finished in order for it to show up. Screws are slower than belts. With high torque...