Separate names with a comma.
Some features disabled for guests. Register Today.
"Yes it does happen when i only have one Y stepper plugged" Ok, but does it matter which driver? Y or Y2? Both? Contact Us
Got it. So to me, that indicates a short and not software or grbl config issue. Like the X dir pin is shorted to the Y pin on the board itself....
"Weirdly enough the axis that is NOT supposed to move but does only goes in a positive (forward) direction and does not go back." Seems to me...
I think some allow you to even ignore them.
Not unless you know what line it stopped on. If you do, you can edit your gcode file to remove all the lines already processed, but you need to...
Awesome! [IMG] (2 shakers, one sharmstr)
Not yet: X and Y probing (Community demands) · Issue #79 · OpenBuilds/OpenBuilds-CONTROL and MACROs still has a lot of growth ahead...
I just installed it. If you go into settings, you can change the header so it doesnt output the G54 P0.001 codes.
G64 isnt supported. Change your first line from G17 G90 G64 P0.001 M3 S3000 To G17 G90 M3 S3000 I'm not familar with Dmap2gcode so there...
Ah. I see you edited it 4 mins after I responded. We dont get notifications on edits so no way of knowing unless you tell us. Glad you are sorted.
Excellent! :thumbsup: So, I'm guessing your "motor syncing" issue in the other thread is also solved?
Thanks for the pics. So, as mentioned before, you need to fix your Z axis lead screw. It should be flush with the bottom plate. I provided...
Here's some more information on increase the Z clearance: WorkBee 1510 gantry height
The lead screw, if built correctly, doesnt extend past the bottom plate at all. At the 34 min mark of the build video, they tell you to make sure...
You should set your speeds and feeds within fusion. If you dont like the sound of the cut, adjust in Control, then remember to adjust in your CAM...
That sounds like a wiring issue. I had that once and one of the motor wires became loose on the black box and was shorting out. It looked like...
Cool. Moving on..... Is your gantry square in a resting state? I had an issue with the gantry no being square early on: OpenBuilds WorkBee...
Did you actually verify that one motor wasnt moving the right way? Or did you just switch the wires hoping that would fix it? This is important...
Swap either A+ with A- OR B+ with B-
There's no drilling cycle for GRBL, so unless you are using control software that can do the conversion for you, then no. No mater what machine...