Separate names with a comma.
Some features disabled for guests. Register Today.
Can we be clear about units - you said when you jogged 100mm it moved 50cm (that's 500mm). Could you please copy and paste here the contents of...
If they work loose again consider using (non-permanent) loctite on the grubscrew threads. Alex.
Your first line of G-code is telling the machine to go up by 15.5 mm, but you are starting at (machine co-ordinates) 136.95. That would take it to...
Your Duet interface tells you both work co-ordinates and machine co-ordinates. What do the machine co-ordinates say immediately after homing. Alex.
Hi Brandon, I'm no expert on OB control, so you may have to wait for one of the others to come along, but what are your grbl settings - especially...
Very interesting idea. You won't be able to cut all the way through and have parts drop out the bottom though unless you have a way to hold them...
Better to make it a build report in the builds section. You can write it at your leisure and make it public when you are ready. If you put it...
Hi @Mark Carew, the Dewalt installation video on this thread recommends putting the router mains cable in the drag chain, but we are regularly...
Main thing is where the cable runs - if it is alongside low voltage stuff you effectively have a capacitor between the mains and low voltage...
Where have you put your router mains cable? It sounds very much as though you are getting electrical interference (EMI) falsely triggering your...
The output of a stepper driver is a series of pulses. If microstepping it's a series of pulses of varying magnitude - you can't easily measure it....
It looked to me as though it wasn't pulling off far enough to release the switch. Alex.
I only get to see one of the videos. Your description of the homing sequence sounds correct, but what I saw was it hitting the endstop and...
They sound fine when they are moving, but what's going on when they reach the end of the axis? I see from your grbl settings that you have enabled...
Same way as if you were probing the top of the workpiece. In fact if I want to probe Z off the spoilboard I do a full XYZ probe off the top of the...
To Enable USB Selective Suspend in Windows 10, do the following. Open Control Panel. Go to Control Panel\Hardware and Sound\Power Options. On the...
Neither is better - I use both on occasions. There is some advantage to probing from the spoilboard if you need to do a tool change as you may...
What version of the firmware from Ooznest are you using? I strongly recommend updating to the latest (V1.0.7), especially as you are used to grbl....
At the risk of telling you things you already know; The home position sets the machine co-ordinates system - with the Duet/Ooznest's firmware...
That's sorted it - thank you Peter:thumbsup: Alex.