Separate names with a comma.
Some features disabled for guests. Register Today.
Flashed 2-axes firmware before? Wiring issue (test switches on troubleshooting tab)
Doesn't look correct no. Are you sure you converted all the SVG entities to PATHS? Covers that as well When posting asking for review, we also...
I am not sure if Lightburn can edit Grbl settings, why not use CONTROL, tune it correctly: Grbl v1.1 Configuration and Grbl v1.1 Configuration...
That's unreasonable request. One sometimes do need to use intermediate CADs to cleanup a file for CNC use You need to give CAM (most not only...
Let's add EMI to the list, logs would have been helpful to confirm: docs:blackbox-x32:faq-emi [OpenBuilds Documentation]
Loose setscrew on Z axis coupler? Loose terminal causing intermittent loss of motor power one of the 4 wires? Z Max Rate / Acceleration set a...
All of that's in the Documentation: docs:blackbox-x32:start [OpenBuilds Documentation] Limits are in section 3.4
Couple possibilities grubscrew on shaft coupler slightly loose causing slip during direction changes max rate set too high - causing stall when...
You had a ticket logged with the store already - check your email. We approved RMA
Ok good ,so wasn't caused by the VFD. Just a precaution, try to prevent the same thing happening to the replacement :thumbsup: When you receive...
The log output isn't going to magically change. Stop posting it and go to work checking your wiring against docs.openbuilds.com/blackbox-x32...
Yip short between V+ and GND
Cut recipe aggresive enough to induce deflection?
Well, then it might be backlash. Hold endmill and give it a firm wiggle - unwanted play will show up as a feeling (sense of touch is orders of...
Yes steps would scale over distance. Tramming: A generic guideline
Or a good quality measuring tape? Longer = less error percentage HOWTO Calibrate your CNC Machine for MACH3 or GRBL (without the wizard but tips...
Use the longest distance possible (100mm default is just entered by default for folks with small machines like our Minimill)
Can you please do me one last favour (before we swop it and a replacement gets damaged too) Power up VFD and measure the two wired you had on...
[ATTACH] Comparing to a standard machine profile (LEAD1010) the only change I see around there is $30 (Expected, just make sure to use M3 S24000...
Every unit is extensively tested (including USB comms as part of firmware flashing and the test procedure) in the factory. So if its a faulty...
