Separate names with a comma.
Some features disabled for guests. Register Today.
Step - / Dir - = GND Step + / Dir + = signal (logic high) Real leadshine or fakes? Most external drivers allow logic high signalling too. Using...
Then I am out of ideas (apart from jokingly suggesting an Upgrade to BlackBox X32?) Might want to check in with the vendor
BlackBox outputs + signals, so if you need pulldowns, you'll need to add inverting buffers (or N-channel mosfets) to do that. Fan is for cooling...
Did you try this yet?
a) its not a power strip b) plugging, say your 24v PSU into Normally On, will turn OFF your machine (no movement) when the machine turns on the...
Great even easier then (: Finish the Build as per the instructional videos
That would be similar to a LEAD1010. Don't skip steps in Docs (; or you'd have had a backup (:
Correct, needs a HOME up and away - get the switches, or learn to fake it :) But really, get the switches. Setup Homing. You'll just have a much...
Best option: Get switches. So worth it! Xtension Limit Switch Kit 2nd best, learn to Fake home properly How to 'Fake the home'
Maybe flashed with the "and erase settings" option? Reload machine profile (select machine from list in Grbl Settings tab) or restore last good...
It doesn't home. It does a Z clearance move in G53, but thats not going to interfere (that is best practice to allow safe moves without crashing...
Same error as Post Processor Fusion 360 - make sure to set the WCS
docs:blackbox-x32:firmware [OpenBuilds Documentation] with the correct selection should be all you need
Try adding its header T1 G17 G21 ; or G20 (mm or inch depending on what the other file was CAD as) G90 M3 S15000 (I still am suspect of the...
You'll have to use custom Macros on the Macros tab Constant force springs or counterweights might be something
It could cause a probe crash though 1mm/s^2 is extreme - Grbl does do a decelerate move after contact. CONTROL's macros uses stopping position...
Its usually operator error. Post your gcode, screenshots etc if you need help
Also, make sure to setzero, or move in Machine Coordinates
Don't forget the details our support team recommended you supply for our forum members to help you
If you have the X32: Checkout $44, 45 etc You can define your own homing sequence in grblHAL If you have the older 4X: You can recompile with...