Separate names with a comma.
Some features disabled for guests. Register Today.
As long as it posts proper grbl gcode, then yes. With that said, I've seen other post about Fngrave, so I think you're good to go.
Is that a machine within a machine? :)
If you mean "before you save the gcode", then yes :) Keep in mind that you'll probably run into other errors down the road and you should really...
You cant have tool change commands in your gcode. Either take out the T1 line, or use a better Fusion/Grbl post processor like this one:...
Cant recover unless you know the exact line it died on. For the port disconnect, there are a few possibilities. 1 is a sleep or power saving...
I've gone through a few different setups. Currently, which I'm happy with, I have 3 20x80's laying on the 80 side with bracing in between...
Clearly the brains of the team. :)
Again. Working fine for me. I've attached a PDF version of them. There's also a video: [MEDIA]
Working fine for me.
OpenBuilds Portal! LOL.
Awesome. Really want to see where this is headed.
Here ya go: OpenBuilds BlackBox 4X Documentation
No thermal switch on the fan for the Blackbox. For the meanwell 24v power supply that OB sells, yes.
You might not have to change it. Basically, if you tell it to move X+ and it moves X-, invert the direction in grbl settings :)
As Peter said, verify that $4=1. With that said, the fan is connected to the 24V side and should spin even if you dont have your computer plugged...
No. But you either have to switch the motor wires or invert the motor direction in your setup. If it were me, I'd just keep the motors wired the...
You can try installing a previous version here: OpenBuilds/OpenBuilds-CONTROL I have a feeling that the two aren't related, but its a place to...
For speed control you can use something like the SuperPID: www.SuperPID.com - Super-PID Closed-loop Router Speed Controller I have one but have...
Your config looks good. Have you calibrated your steps/mm? Does it throw an alarm?
It did. Then it didnt. Then it sort of did. Like I said, there are a few of us working it out, but there's no ETA on when that will happen and...