Separate names with a comma.
Some features disabled for guests. Register Today.
I clamped a piece of 2" x 1" to the side of my bench, screwed a large cup hook into the top and hung my router cable from that. Made sure I had...
As @sharmstr said, but keep mains wiring away from low voltage stuff. I suspend my router cable above the machine. Alex.
Your gcode is coming out without specifying what units its in. If you use the Grbl (inch) (*.gcode) post processor in Vectric it will put a G20...
PS if you are using the G code (inch) (*.tap) post processor that processed a simple profile cut correctly (apart from the T1M6) but it didn't...
What post processor are you using - you should be using Grbl (inch) (*.gcode). I just did some experiments and Grbl (mm) (*.gcode) will happily...
Hi @Pidiln, I have wound up my PC to have a look at the problem. Could you post your gcode file here (you might have to change the extension to...
Hi @Pidiln /Larry, have you checked your settings in V-carve (mm/inch)? And are you using the same post processor? Alex.
You are welcome - that's what the forum is here for. Alex. :thumbsup:
It really doesn't matter @DannyDog - I have an 18mm spoiler board, but as most of the stuff I do is really thin I have another board on top of...
I had gone back to an old file created (in Fusion) when I was learning it. Created an extrusion to cut out a section of another extrusion, but...
grbl doesn't handle tool changes - separate toolpath for each tool. Alex.
This could be a cad/cam problem. What software are you using? I had a similar problem recently where I had stupidly failed to notice my toolpath...
Too far from me. I hesitate to recommend this on bits you have just bought, but enlarging some of the holes in one gantry plate would allow you...
Hi @DannyDog, assuming you have assembled it correctly and loosening the bolts, pulling it square and re-tightening doesn't fix it, you may have a...
Hi @DannyDog, firstly - just checking the obvious - did you put precision shims where they are needed? especially between the bearings when you...
For the benefit of people who might know the answer I assume @Colin Mccourt wants a post processor for Vectric software. Alex PS you could try...
Amazon tend to be over priced - try Rapid online or RS online. Alex.
Openbuilds sell the wiring, tried to give you a link but their server had a problem. They do, I believe, post small items which would avoid...
Hi @DannyDog, Ooznest sell the workbee as a complete kit (although they have changed the design recently and use a lot less wheels). If you have...
This video tells you how to unlock an excel spreadsheet....