Separate names with a comma.
Some features disabled for guests. Register Today.
Those instructions seem to match those from Autodesk, as an alternative you can install the post processor locally - instructions here -...
You just need a grbl compatible post processor for Fusion - see here ;- Fusion 360: grbl post processor install (the easy way) Alex.
Hi @ricklach, I have a workbee 1010 (leadscrew) which has the advantage over belt drive of (approximately) an 8:1 gear between the stepper and the...
Fans can have PWM output, so could be used with appropriate interface to control router speed. As this involves mains voltage I cannot elaborate...
Fans are not on/off - you need to specify which fan and speed - read about M106 here ;...
Yes @ricklach, do let us know if it continues to behave itself. With belt drive you should get +/- 0.2 mm resolution, depending on how well the...
0.05"=1.27mm. Most of us in the UK have changed to metric now, but being old I still use both ;) sometimes for the same piece of material -...
Hi @ricklach, re not returning to work zero, after you have set motor current - using the pointiest bit you have; Jog to middle of machine, put a...
Hi @Lerronious, the ratio Peter mentioned was the voltage ratio - you need two equal resistors wired in series. 10 volt output at one end, 0 volts...
Hi @ricklach, don't waste aluminium on these tests - some scrap mdf would be ideal. I am 99% certain this is not a software problem - I think...
Blackbox from Openbuilds BlackBox Motion Control System. There are others, but I am biased :D:D:D:ROFL: Alex. And software to control it is...
EMI (caused by static) is the hardest to pin down and not the most likely of causes, but the static builds up in the vacuum hose because of the...
It shouldn't be difficult to swap the wiring between your Z and Y axes @RandyK. Post a pic of the wiring at controller end and stepper motors so...
Hi @ricklach, if you continue to have problems post a pic of a circle (just 3mm deep) labelling X and Y axes. Alex.
Not a problem. Alex. :thumbsup:
Also, don't forget @Peter Van Der Walt's suggestion in your other thread - VCarve GRBL Post Processor Mods. (try to stick to one thread for...
You are welcome. Alex.
I'll have to experiment to see if I can get that to work on my setup - don't have Internet on the machine I use with my workbee. Thanks, Alex.
Use the grbl (mm) or grbl (inch) post processor. Not sure about the Vcarve Pro option (I have just started using the desktop version) but you can...
Hi @GeoffH, is that an online only viewer? Alex.