Separate names with a comma.
Some features disabled for guests. Register Today.
Use a bearing to support both ends - don't load your stepper unnecessarily. Bearings are relatively cheap to replace when they wear. Alex.
I clamped a bit of 2" * 1" to the side of my bench, fixed a large cup-hook to the top and hung my router cable from that. Made sure I had enough...
If you have the Duet controller with your workbee use the post processor from Ooznest with Fusion...
If you are asking what post processor to use with Aspire to create g-code then use "Gbrl (mm)(*.gcode)" post processor. Alex.
As @Peter Van Der Walt said emi is unlikely to cause problems. When it does it can be very puzzling and on rare occasions seriously damaging. I...
I'm getting old - eyesight is going and struggling to read that on my phone, but it looks like one that works. :ROFL: I have a feeling that you...
Hi @MB460, may not be related to your problems, but what post processor are you using with Fusion? Alex.
Hi @Tajudeen, looking at the pictures you posted earlier it looks as though the first switch was wired NO and the other two were wired NC. Have...
Hi @Tajudeen, I think your problem may be in your grbl settings. There are people here who are far more expert than me on this but it would really...
If it does use the CH340 chip then the driver is here ; CH341SER.EXE - 南京沁恒微电子股份有限公司 Alex.
Err..... that appears to say the Makita brushes last longer. Alex.
Hi @Mallardduck31, a bit more info please - what machine, controller and control software? Alex.
Now you just need to tidy up your Web page on the learning portal so that the links work :rolleyes::rolleyes: Alex.
Congratulations - well done! Alex. :thumbsup::thumbsup::thumbsup::D
Didn't fully understand what Paul was trying to do - I agree - don't drive a relay with pwm - it won't last long! Alex.
Not knowing what the 0-10 V output can source in terms of current I would be inclined to increase the base resistor from 1K to 5K. Otherwise that...
A 5K/10K resistor between 0-10V and transistor base - transistor not critical as it will dissipate very little as it will be fully on or fully...
Hi @Paul Stoller, you could use a simple transistor switch circuit to turn on a relay when the 0-10 V output rises above 0.7 V. You must wire a...
Hi @Paul Stoller, I don't understand your last post. A voltage regulator takes an input voltage above it's rated output and limits it. So a 5V...
The link above (OpenBuilds CONTROL Software) leads you to a post by @sharmstr which in turn includes a link to the Ooznest site with full...