Separate names with a comma.
Some features disabled for guests. Register Today.
Yes, overheating is covered in docs:blackbox-x32:currentadjustment [OpenBuilds Documentation] Fan must spin or it will overheat again. Try...
At first yes, the additional uncalled for INF steps - not sure If correctly installed you should see it in Device Manager under Ports [ATTACH]...
In your video (....1111425.mp4) you move one Entity, not the entire document. Select everything to move first (ctrl+a, or use the Selection tool...
INF? Per docs:blackbox-x32:install-drivers [OpenBuilds Documentation] we link you to the nice Installer version (EXE) Perhaps you do have the...
Stock is on the conservative end (can usually tune upward) unless there are any 3rd party parts involved (different steppers, different PSU,...
It shouldn't so how are you doing it? Using the Move tool or the Transform (type values into boxes to move stuff) tool? Are you paying attention...
It could be that the strategy is a bit aggresive, but the repeatable offset "feels" more mechanical - if the cut recipe was off I'd expect it to...
Sure its a 1/4" shank? 6mm shank bits installed in a 1/4" collet feels like they fit, but pushes the endmill deeper during plunge cuts (not...
Plasma On/Off is in the CAM setup - totally different application Check the dates of the video, BlackBox X32 is newer and V1.3 upwards uses the...
Also, don't use 100mm, use as far as you can move per axis
Settings can't affect connection, so do go over that wiring, before its too late (: Still either stalling (Acceleration/Max Rate set too high)...
Before or after? What's differences between the two jobs? Down to "i did perform a toolchange" or any other cluea to go by?
You already have a store ticket, will check in and have them swop it out for you for the USB issue. (; sounds familiar - see Page 1 of this...
You only need to install drivers once. Does it connect now? If so. Drivers: DONE Fan and Motors needs POWER. If neither works, you don't have 24v...
Shorts in cabling somewhere? Could kill the BlackBox. See section 6.3.1 of the FAQ page the onscreen error in CONTROL was pointing you to:...
As both PCs do it, any chance you used the same monitor? Does unplugging cable between PC and Monitor open the short? (HDMI's DC GND and USBS DC...
Unlikely to get added soon. Can add yourself macro files on the USB for it. But in practise, manual control really shouldn't be needed. CAMs all...
Add it to your gcode headers / footers.
Most likely the LM 358 just behind the 0-10v potentiometer.
Sounds mechanical. Either Z binding or slipping. Check wheels, leadscrew, nutblocks, grubscrews tight on shaft coupler. Could also be...