Separate names with a comma.
Some features disabled for guests. Register Today.
There are a lot of major changes with V1. 07, and it's very much in the melting pot. I intend to have a play with it, but wouldn't recommend you...
Also have a look at Duet Controller/Fusion 360 post fix. Ignore the later stuff about V1. 07 for now. Alex.
Quite a few people here use Fusion, almost all of them more knowledgeable than me. I started using it in February and can now use it for any 2 or...
First a word of caution - the Duet uses Rep-Rap firmware similar but not exactly the same as grbl, so no, not every grbl post processor will work....
Don't go there (V1. 07) unless you really know what you are doing - it's a beta and under constant revision. (Also Ooznest are planning to do away...
Hi @MakeItJustBecauseYouCan, if you have normally closed limit switches you need to use a spare endstop input on the Duet for a probe. I've...
Thanks @GeoffH, are you using a probe? How does that work in the new DWC? I saw a screen shot that suggested that was different now. Hopefully...
Hi @GeoffH, @Ryan Lock, I'm guessing that if I install version 1.07 I'll have to change my limit switches to NC? Alex.
Re the My_PostP folder, if you save your modified post processor somewhere else you can install it as a new post processor in the main post...
Depends what version of the firmware you are using. I'm still on a relatively early version (normally open limit switches) so wired it in parallel...
Glad to see that seems to be sorted. Have a look at the Blackbox controller from Openbuilds - very good drivers and lots of protection features...
Current version of grbl is 1.1 You can get it here gnea/grbl This might solve your problem. Alex
This line? G90 G17 G92 X0.0 Y0.0 Z0.0 G00 Z2.0 G00 X10.0 G01 Z-2.0 F400 (first 5mm hole) G01 Z2.0 G00 X30.0 G01 Z-2.0 G01 Y1.5 (compensation for...
It depends on how you defined curves in Aspire. I'm not a Vectric user (yet) - have just tinkered with the trial versions - but if I remember...
@Rick 2.0's suggestion was probably the easiest (and quickest). Alex.
You should still be able to change the direction settings @Bill Lawrence1. Do you know what software you are using to send G-code from your PC?...
Please note @David the swarfer referred to TOOL movement - I believe your machine has a moving table - Y+ will move the table towards you. Alex.
Lead 1010 and DeWalt or Makita - yes Lead 1010 and air-cooled spindle (not too big and heavy) - yes Three routers /spindles - no! - too heavy &...
But don't run it from the same PSU you use for your control electronics - as @Peter Van Der Walt said the inrush current when you start it could...
As we have said - your pictures show a problem with your Y axis. The flat bits on your circles in the X plane means that the Y axis is not moving...