Separate names with a comma.
Some features disabled for guests. Register Today.
Use the Jog speed slider to the right - as the jog rate has always depended on Grbl's Max Rate, the input field was well confusing, the slider...
Unconventional, but can be done. Clear the gcode editor, then "update" the blank view [ATTACH]
Lets double check your Grbl Settings (i did scan through quick on my phone) did you change anything like $5 from its defaults? (Should be $5=7)
As soon as the short (blocking diode looks like a short when reverse polarity is applied) is removed
Limit 1.jpg has the rubber insulator on the wrong side (thus switch pins shorting on metal frame, might even have damaged port). Rubber is to lift...
Great. Also spend some time tuning Acceleration and Max Rate - Grbl Defaults are quite slow (for a reliable start) but if you put in a little time...
1) provide a Grbl Settings backup for review 2) provide detailed pictures of all wiring
BlackBox has a reverse blocking diode at the input. Reversed polarity should throw the Meanwell into Protection mode. Going by what you are...
Brush replacement due. Excessive sparking creates EMI, particularly under load, when the brushes are worn
Sadly wiring mistakes are excluded from warranty. OpenBuilds Warranty Warranty is for material defects, factory related issues.
Does the red Fault LED light up when the motor does not move? Power cycle clearing the error sounds like it would be. See 2nd half of...
Reverse polarity can sadly destroy it. If its not powering up anymore, it is sadly done
Followed all the setup steps? (Firmware V1.57? BlackBox USB cable unplugged? BlackBox otherwise in working order (all light still on when you...
Probably unrelated but you are using a proper browser like Chrome?
If it just spins, one of the values you have entered into toolpath parameters might be blank or not be making sense. Review your cut parameters or...
That would be You do it from scratch (as its a different controller) but can borrow inspiration from the old values. Will need tweaking either...
Here's to hoping it will be the recommended one (: so we can either resolve or eliminate
No, double check what I said. Try with $33=1000.0 in Grbl Settings (not the VFD).
Did you try VFD Spindle Control via OpenBuilds BlackBox Controller and Software
And the Serial Terminal log does reflect the correct commands being sent?