Separate names with a comma.
Some features disabled for guests. Register Today.
Align your CAM and physical workflows. Probing front left = set origin front left to match You want to set Zero where CAM expects Zero. With...
Relay contacts bounce when closing, so you may see some switch bounce / inaccuracy on probing. Probably fine for touchoff, doesn't need the...
steps per min is a rare one, so mind the change of units to mm/min but for perspective our ACROS, run our NEMA17s on our BlackBox. Belt drive....
Well, Is part of the issue A proper controller like a docs:blackbox-x32:layout [OpenBuilds Documentation] has an entire filter stage between the...
Defaults are fine, that value doesn't do what you think it does (: Grbl v1.1 Configuration It's more "how long a pulse does your stepper...
If it was working fine, why would you load a custom machine profile to it? Grbl Settings are stored on your controller - that tool is for initial...
That would require SMD rework skills (: Not economical to repair - seems to have served you for many years.
Store will reply to ticket logged via email. Check your spam folder too. Warranty issues (if still valid, that seems to be quite an old one) are...
Turn off hard limits and see if it helps. If does we revisit your limits (maybe EMI) X32 firmware up to date? Wifi + hard limits had a bug a year...
On boot up early in the video you can see Grbl-Alarm top right. Your BlackBox is alarmed before we even connect to it It won't accept jogs while...
Checkout https://www.rockler.com/rockler-vacuum-pump usually used with https://www.rockler.com/rockler-vacuum-clamp-pod-kit
Sadly per section (3) of Terms of Service and Rules | OpenBuilds not allowed sorry
Should not be needed. But there are reset buttons on both, way easier than power Is your Interface on Firmware V1.57? If it is, then check your...
Consider selling it as-is before its taken to pieces, and putting that toward a new Machine Kits - Page 1 - OpenBuilds Part Store Kits =...
Well glad to hear you are up and running! If you encounter any issues, let us know!
@Lewis Trafford would you please contact the Store via Submit a ticket - we'd love to swop out that BlackBox for you - so we can investigate yours...
VFDs in general are somewhat generic, existing writeups read along with manuals should get you there. Just we can't officially say yay or nay as...
Your VFD vendor would be better able to answer the VFD specific questions. We provide the 0-10v signal, and most VFDs can be configured to ignore...
What control system / stepper drivers ? Whats the application for these two motors? Load / Torque Expectations? Sync'ed as in both perform the...
We have seen switches break - especially if rammed hard with the machine Motor weirdness? docs:blackbox-x32:faq-identify-motor-coils [OpenBuilds...