Separate names with a comma.
Some features disabled for guests. Register Today.
I use a 611 without a shim and it works fine. If you have a 3d printer: Dewalt Router Mount Shim 71 to 69mm If you dont have a 3d printer:...
Hey Colin, Regarding the dust commander... I have a similar setup for my vac I use around the shop. I used it on my workbee for a few weeks...
I think it might be tough to find control software for Chromebook, but that doesnt mean it doesnt exist. Google or maybe even searching this...
I'm using drop in t-nuts. Install them on the board. Make sure they are snug an parallel to the slots. Drop the board onto the supports....
I did forget to change $4=1. I had just copied my settings that I used with the arduino and dq542mas. So, after changing that, the Z led isnt...
Got mine yesterday. What do the status LEDs on the motors actually mean? I thought I saw it discussed recently but couldnt find the post....
Hey Peter. Getting app-update.yml not found error when trying to auto update from 1.0.144 to 1.0.147. I'm going to uninstall and install 147...
Hey Alex, G90 Absolute doesnt mean what I think you think it means. :) Its sounds like you think that G90 means that all moves are positive....
Maybe you guys should confirm that you are on the same firmware and web interface versions. Again, I dont have a duet, but according to the doc,...
Did you check your pulley? It might be loose. Did you calibrate your steps/mm? [MEDIA]
Looks like its in Settings - > User Interface: Duet Web Control Manual
Workbee with Duet controller
Tool changes aren't supported. You need a separate gcode for every tool change.
g2/g3 are arc errors. Again, I dont have a duet, but I believe that error message is misleading. What's the next line of gcode after this one:...
No. When you post, there is a selection for "Unit" in the lower left. Change that from Document to MM.
Your CAM is in inches. Change it to mm. The swarfer version of the stroom post will warn you about that: swarfer/GRBL-Post-Processor
My point was you dont HAVE to issue it. Sorry for the confusion. I should just keep my comments to myself since I dont have a duet. :)
That certainly makes more sense. The ooznest wiring diagram shows this:...
Guys. The M500 where its stored. Its not a command you enter.
LOL. I knew it did when I was running the xpro v3. I recently switched to and uno and thought I'd it did, but then you got me doubting. I...
