Separate names with a comma.
Some features disabled for guests. Register Today.
@matcoller I can probably help with rotating the screen. I'm guessing you had issues with rotating the touch events as well. I dont know if it...
Is your phone and control on the same network?
Awesome. That will make it much easier to read.
and add G21 and G90 to it as well (not necessary, but good practice as noted in the other thread) G21\nG38.2 Z-25 F100\n G10 P0 L20 Z3.3\n G21...
@matcoller a few suggestions for you. Use a stylus. Give the phone pendant a try. Maybe rotating the screen 90 degrees might help??...
That's how I did it. :)
I put it into fusion this morning. I'll post it up later.
I'm looking for a few people to test an updated Fusion 360 post processor. The new version will create separate gcode files for every tool change...
Yes. They probably dont have it listed on the Lead page because it was just released. In the last 3 months I've used the Xpro, arudino with...
I hear ya. It takes some time. Anyhow, in your first post, you have your switches wired to Normally Open, so change your "invert limit pin" to...
I have my switches wired to normally open so my invert limit pin setting is disabled. In your images, you still have pull off set to 1mm. Not...
Thank you!
I had the same problem. 1mm is not enough of a pull off distance to "unclick" the switch. Change it to a higher value. Like 3mm or even 5mm.
Which holes on the Z axis plate does this mount to?
You mentioned that you are looking at the LEAD 1010, but didnt say what options you were getting with it, if any. The base config is just the...
Just a heads up here. I suggest adding a G90 to the end of your macros. I ran into an issue over the weekend where issuing a G0X0Y0 via serial...
After a bit of a false start (bad muscle board), I've been running this thing for 2 solid days and its performing great. I have a customized...
Its a Mach3 card. You didnt mention if you installed Mach3 or not.
Totally. What may help is using something like openbuilds cam to make a simple square. Then read the gcode that's generated. You'll learn a...
Yes you do. G0 uses rapid speed. You need G1
