Separate names with a comma.
Some features disabled for guests. Register Today.
Thanks @Peter Van Der Walt, finished lunch now. Alex.:D:D:D
Hi @Matt Thorniley, I'm on my phone at the moment and about to have lunch, if someone else doesn't give you the info you need before me I'll give...
What post processor are you using with Fusion 360? I haven't checked all your G code (its a long file), but you have tool changes in there which...
I believe that in the Duet Web Control you can increase feed rates while a job is running - courtesy of the rep-rap firmware that allows you to...
Yes Peter - my bad - I didn't read the post properly. Sorry!:oops::oops: Alex.
See post #369, page 13. Alex.
I use (cheap Chinese) V engraving bits for jobs like this - 10 degree angle 0.1 mm tip diameter. They are a bit more robust than a 0.1mm endmill....
I'd really like to be able to do that with my workbee, but the Fusion post processor for the Duet doesn't generate line numbers. Alex.:(:( EDIT;...
To answer a couple of your points (I have a 1000*1000 workbee by Ooznest in the UK) I can't do a direct comparison but see a lot of similarities...
Indeed @GrayUK - an awful lot of critical testing happens AFTER the event that highlighted the need for it. Alex.
I am not aware of a manual for the workbee with duet controller - although the wiki for the duet is useful it is important to remember that...
On PAUSE it is supposed to homeall (ie go to limit switches) - on RESUME it should go back to where it was when you pressed PAUSE and carry on...
Did you find the answer @Colin Mccourt? I would be interested to know that myself. Alex.
Sorry @Colin Mccourt I don't know the answer to that. The worst case, if you turn the machine off, is that you would have to run the whole job...
