Separate names with a comma.
Some features disabled for guests. Register Today.
So now we know the machine obeys G code instructions, but not when they are in the homeall file or in a macro - that doesn't make sense. Type this...
Sorry @Gina Botfield, I think we are going to have to wait for @Ryan Lock on this one - we will probably both kick ourselves when we find out it...
Did you get any error message - was the machine telling you it was outside machine limits again? Alex.
Go to system editor and edit homeall. Copy everything, go to macros, create new macro, paste everything from homeall into it, save it as homeall...
Sorry @sharmstr - getting confused by my upside-down, back to front Duet again. Alex :oops:
And what is the head position if you jog 100mm in X and Y and 10mm down on Z? Alex.
I'm assuming that the head position says X0, Y0, Z0 when the machine is touching the limit switches, and that the machine stops when it hits them....
Hi @Gina Botfield, sorry - it's only the workplace co-ordinate system that's blue. The rest are grey. If you are in machine co-ordinates nothing...
I am going to go and check on my machine so that I tell you absolutely correctly - will be a while as I have to wind up an old computer and...
This is the one I use when I want to use @sharmstr's post processor [ATTACH] Alex. I just used it to post process your Fusion file - it still put...
Hi @Matt Thorniley - just started looking at your files. You might have to wait for someone like @sharmstr to get up - I can't see anything...
On the right side of the Duet Web Control when you have clicked on Machine Control there are some wide blue buttons. One says "Work Co-Ordinate...
Sorry - just read your post properly - back right up should be the maximum settings for your machine - X550, Y520, Z94. Are you sure you are in...
Yes - the homeall macro should work - small movements away from each limit switch and then back until the limit switches are triggered. Z first...
Hi @Matt Thorniley, just checking something (haven't had a chance to look at your files yet) - can you still jog your Z axis up and down as...
Hi @Gina Botfield, what happened when you did step 4 of Testing Your WorkBee - testing limit switches? Alex. PS if you look back at message 19 you...
Hi @Matt Thorniley , it's a bit late now, but I'll have a look at your nc file tomorrow. I suspect your problems are more to do with Fusion -...
That's right Gina - see my last post - time to take a break and sleep on it. Alex. :banghead:
Hi @Gina Botfield, I have sent Ryan Locke an email linking him to your thread. I can't see what you have done wrong and at this time of night the...
This is the back of the machine (mine is leadscrew so motors will look a bit different) [IMG]
