Separate names with a comma.
Some features disabled for guests. Register Today.
I always do - it avoids any possibility of the problem you had. Alex. :thumbsup:
After setting workplace zero did you raise Z before running your G code file? Alex.
This might help Speeds and feeds Alex.
It was only the Y axis in my case @Benjamin Vg. If your machine properties are correct and you are in machine co-ordinates then home should...
Hi @Benjamin Vg, did you solve your machine set up problem? If not I can only suggest contacting Ryan at Ooznest as you appear to have done...
And later??? Alex. :D:D:D
If it's an open source project look for the files - lots of people on here use sketchup so have a look through the project section. There are also...
Hi @Benjamin Vg, it looks as though you are editing config.g correctly - check that you have switched to machine co-ordinates and then see what...
There is some evidence of the edge of the tool in both axes. 1mm doc is a bit much for a bit that size - lots of lateral force although there...
In the web interface there is a settings tab. If you open that you should see a system or system settings tab (away from my machine at the moment...
I have just had a look at the build video - the only place I can see to put shims is between the X axis plate and the Z axis C beam - as this...
Did you use the system editor to change config.g? - settings, system (I've made that mistake myself) Alex.
You probably already know most of this @Steveathome, but for the sake of completeness I'll mention everything I can think of. First try to find...
Hi @Sam277, does what you use as a pointing device react with software in the same way as a mouse does? Can you let us have any details of the...
Reminds me of when I was teaching technology (electronics/robotics/engineering) to 16-18 year olds. 6502 or 6800 microprocessors, separate eprom...
I keep my eyes open for anyone throwing out old wardrobes - lovely mahogany or sapele, sometimes oak. Alex. :)
I found lots of discussion on spoiler boards by searching the forum for "spoiler board". Didn't find any threads dedicated to this subject but...
What plane/s is/are the movement/s in? Difficult to put into words but if you are looking from the front of the machine does the router mount/...
MDF doesn't stay the same size or shape I'm afraid - it will even sag under its own weight. Most people find it's necessary to take a skim off the...
If you have normally open limit switches - if you have normally closed limit switches wire them in series. Alex.
