Separate names with a comma.
Some features disabled for guests. Register Today.
Depends what you find. But it doesn't look good. I assume you worked through all the steps that the onscreen error message (with a documentation...
Cables first, lots of Z issues so Z motor cable first. Don't forget Z mechanicals (slipping shaft coupler would do some of these too)
Yes, sounded like some kind of Mac/Driver issue. One thing you can try is to move the Run/Flash jumper under the top cover to the Run position...
Yes, see docs.openbuilds.com/blackbox-x32 to learn all about it
Sounds like something took it out. Look for shorts (been in use a while so chaffed cables or loose terminals)
Fix the DXF Problems with importing DXF into OBcam
5.5v coils and 8mH inductance - will be a bit slow but will run
Try a PC just as a test. Have you worked through
Follow docs:blackbox-4x:hello-world [OpenBuilds Documentation] to see zeroing in action
Getting started with Javascript Macros in CONTROL / Library of Macros created by the community
Double check Power Supply Double check Grbl Settings (if its an X32 you must have $4=0(Disabled)but if that's been changed, you might know what...
JS Macro, autorun, $("#portUSB").data().select.val("COM3") (might need to wrap it in a setTimeout that waits for the portlist to be...
It cannot do that. When you change between mm/inch, that selection is stored to LocalStorage OpenBuilds-CONTROL/app/js/jog.js at...
docs:blackbox-4x:hello-world [OpenBuilds Documentation] Homing is shown about 1min35s into the video. Very important step - don't skip homing
As a DIY project, You should be answering those questions (; - use it as inspiration then do your own thing Its as fast as you make it...
If you are going to DIY, this is one of my older designs Pelican Case 3D Printer
Only if you compiled with compatibility mode. Grblhal support has been in CONTROL for over a year
Sounds like it was a little fast, but the nice thing as you develop intuition, is to go with your gut feel, dial down a little, if it sounds worse...
Important reading: docs:software:overview [OpenBuilds Documentation] docs:software:openbuilds-control [OpenBuilds Documentation]...
While running the job, if you chatter (too fast) or burn (too slow) - there's always the FEED OVERRIDE sliders in CONTROL (: - bump it up to 200%...
