Separate names with a comma.
Some features disabled for guests. Register Today.
Looks like you skipped step 7.1 (and a read through section 7.2) when you set up the BlackBox. Docs is important: docs:blackbox-x32:firmware...
Did you remember the jumper wire? Otherwise it might still be a wrong setting somewhere, best to a) check the BB as documented:...
No i meant shimming the gap between the leadscrew (circumference) and bearing (ID) just to rid the noise - there is a little purposeful free play...
That video is stock, so if you want that, you don't need anything else 12 meters = 39 feet - every minute (;
Do the MFD test - if that comes out fine, the issue was your material. If not, then time for a closer inspection. Hold the endmill and give it a...
With EMI it's always more important to address the source. The X32 is FCC certified, so more likely a problem coming off the VFD. Proper earthing,...
But did you tell the VFD to ignore the front panel, and use the inputs instead?
That noise typically comes leadscrew pushing around inside the end bearings. Leadscrew is smaller than bearing ID to allow for easy assembly. Can...
All symptoms of Serial Corruption. Typically caused by EMI: docs:blackbox-x32:faq-emi [OpenBuilds Documentation]
V Carving would be best. Try Vectric
You can use 24v - but double check your chosen stepper driver to see if its in range for the driver. Drivers control power to the motors (fixed...
As its a custom machine, pretty much all of them - have a read through Grbl v1.1 Configuration Start with a profile of one of our machines, and...
What type of wood is it? Some cuts fine, some not could just point at inconsistencies in the material, dial it in slower to deal with the toughest...
The vendors we recommend, can be found at Lasers - OpenBuilds Part Store Reliable, compatible, great service - and honest (not like some other...
VREF = a "reference" voltage.. Not THE voltage. Just follow the docs We reinvented how its done to make it easy
I replied to your question about the 3rd party motors. They'll "work" but "as good as ours" because of the technical differences highlighted in my...
Will work, but they won't perform as well as ours. High current rating, but mainly those tend to be High inductance (self braking EMF limits top...
You can still use it with CONTROL PROBE wizard > Probe Type > Custom > click the Gear icon > set your dimensions as offsets. No macro needed
The best is not to (: Rather, rough out with something bigger like a 1/4 inch or you'll take forever, signs tend to be bigger pieces. Then come...
You need a controller running Grbl 1.1f or later. V2 likely runs Grbl 0.9 (2015ish) You can try older software like grblPanel from those days...
