Separate names with a comma.
Some features disabled for guests. Register Today.
Post it as an unlised Youtube video and paste the link
OK so 1204 ballscrew = 4mm pitch. Set steps per mm to around 100 to start off with a BlackBox X32 and standard 1.8deg motors Ballscrews are heavy!...
1) Check Z mechanicals (slipping shaft coupler etc? Loose setscrews?) 2) Check Z-axis Grbl Settings (dial down acceleration and max rate if too...
Try the workaround... Gets you past the point of frustration for now. Then in a week or a month go back and use a process of elimination to find...
Use a computer for initial setup - way easier. Then use the Troubleshooting tab in CONTROL to properly test your Probe. If a short exists, thats...
Have you read post #16 before this last reply?
Pics of the machine, detailed descriptions of drive components (ballscrew pitch, etc), details of limits and where you have them installed etc...
Is machine calibrated? Are you using our probe? Set the correct Probe Type in the Wizard?
OK the IOT is fine - we use it too. That has optocoupled inputs, that's fine Not sure why you mention limits in every reply? Disconnect red....
1) Make sure the two devices can see each other on the network 2) Make sure your PC firewall isn't blocking CONTROL's ports 3) QR code guesses...
The Z probe may have SIG and GND swopped - hiding the real problem (it still exists, but doesn't get in the way) That is discussed in the link...
Can you post pictures of how you wired this? The Dewalt doesn't have a speed input... If its some 3rd party speed controller it might be the...
The software sends an M5. M5 turns of PWM (0-10v is derived off the PWM anyway so it too) and the Tool Enable signals. If its a VFD spindle, you...
First check that bolts holding nutblock to carriage is properly tight, if left loose it can slide there a little. While in there you can feel for...
That message means you skipped at least one, possibly more, of the setup steps of the Interface Documentation...
Normally its configured as a spin down in your spindle's controller parameters.
Indicates a short somewhere else in the system allowing current to flow from spindle body (AC EARTH) back to controller's DC GND Also a safety...
Perfect. Then the probe is correctly configured Does the status change when you clip magnet to spindle? (If so, EARTH to DC GND short somewhere)
Buy genuine, it all works. Buy the knockoff (chinese clone) and you end up paying with time and frustration. Arduinos are made by the folks at...
Noted. Was the controller disconnected during the measurements? Is the Tool Enable LED lit too (same signal lights the LED and triggers the...
