Separate names with a comma.
Some features disabled for guests. Register Today.
Check the Troubleshooting tab - make sure probe is off and only shows triggered once the circuit is completed (magnet > collet > bit > lift plate...
Then it should work fine Check and recheck wiring. Could also be a problem inside the spindle controller perhaps We can check a Grbl Settings...
Peak into the Vents on the side (: [ATTACH]
How is that wired? Control signal or power?
Which version of the BlackBox do you have? (X32 - could be V1.2 or V1.3)
Same concept. Use the probe pin, not the Endstop pins. Arduino pinout here: Connecting Grbl
Use the Router (or a 80-100w CO2 Laser)
Well that's the settings the BlackBox needs, so best defer specifics to your board/machine vendor. $10=511 is needed for CONTROL, but others like...
You can try $10=511 to see if that helps with reporting Machine not moving likely $4 being incorrect etc Did you flash our firmware (meant for...
CONTROL just shows what your controller reports (or fails to report) Being designed for use with our controllers, the advice would have been...
Have a read through docs:software:overview [OpenBuilds Documentation] first CAD > then CAM > then CONTROL Total freedom in each stack, but make...
Rather than Fake the home, just spend the couple bucks and get switches. No need to go through the pain of remembering to "fake it" Fake it till...
A correctly set up machine switches over in seconds. Known offsets between laser and endmill etc makes it easy. Your concept makes sense if you...
Make sure you set zero correctly and make sure you calibrated the machine Also make sure you CAM'ed the origin in the same place you set the...
Disable Soft Limits. Its not worth the trouble. Takes a deeper understanding, impeding initial learning curve
And even then, "cut" is very relative. 5-6w is very little power. You already have a very capable router that will cut that acrylic beautifully...
Unless you are up for fixing python paths and installing pyserial correctly etc on MacOS, might be easier to borrow a Windows PC
Checkout LEAD Lathe
Checkout GitHub - grblHAL/ESP32: grblHAL driver for ESP32 Our default pinmap ESP32/main/BlackBoxX32_map.h at master ยท grblHAL/ESP32 and our...
Perhaps running an older X32 but skipped Sections 7.1 and 7.2 of the BlackBox Documentation?
