Separate names with a comma.
Some features disabled for guests. Register Today.
Wiring mistake: docs:blackbox-x32:faq-identify-motor-coils [OpenBuilds Documentation]
Perhaps docs:blackbox-x32:faq-identify-motor-coils [OpenBuilds Documentation]
And as its inductives, did you remember to change the Limits-V+ jumper as recommended in our docs?
That's an NPN switch, so still needs $5=7
$10=511 ; Status report options, mask Report mask is correct, so Troubleshooting tab should reflect status of switches while testing $21=1 ;...
I am referring to the Report Mask ($10=511), and things like Hard Limits, Pin Inversions etc. Post a Grbl Settings backup - we'll be able to see...
Did you remember to load a machine profile (Grbl Settings tab > Select machine from the list) The profiles sets key things like ReportMasks etc...
You might be better off asking the CarveCo team: Support as its a CAM/Toolpath Setup issue, not a CONTROL issue. They do provide support for their...
Check your gcodes s-values along with your $30 values in your grbl settings
In Vectric that might involve copying the Post Processor and creating a seperate on for for Laser and Router, so you can add the $32 in the HEADER...
Still in Beta, but yeah should get you going
Have you considered Machine Kits - LEAD Machine - OpenBuilds Part Store As your first machine, a proven base kit, that you can modify in future,...
Power on Laser, Power Off Spindle, $32=1 for laser Power off Laser, Power On Spindle, $32=0 for spindle Always a manual process. Super quick...
OpenBuilds-Fusion360-Postprocessor/OpenbuildsFusion360PostGrblX32.cps at master ยท OpenBuilds/OpenBuilds-Fusion360-Postprocessor
Unfortunately we can't provide a definite report for you, as there are a lot of variables at play, also cannot rule out user error. As for the...
Absolutely, bad quality chinese module by any chance? Accidentally incorrectly wired? Well, unless you have Laser Mode enabled? Surely to test...
That should run fine :thumbsup:
Then its stalling or similar, so If in doubt set existing values for acceleration and max rate to half. Do mechanical inspection (forgot to...
The 0-10v output should scale +-0 to +-10v yes. See docs:blackbox-x32:connect-vfd [OpenBuilds Documentation] Well yes, if something killed the...
