Separate names with a comma.
Some features disabled for guests. Register Today.
Not familiar with it, but do check its motors electrical specs (voltage, inductance, resistance)
Similar to how we did the Fasterproms Table? [MEDIA]
Still very much unstable FluidNC support · Issue #283 · OpenBuilds/OpenBuilds-CONTROL with tonne of todo work. We'd love to work on it but this...
You really have to go read the Grbl Wiki. MCS is explained in the FAQ page That alarm is explained in the Max Travel section of the Config page....
Does the Z work correctly. Can only calibrate (dial out manufacturing tolerance) on an axis otherwise already perfect. Wiring, mechanical,...
Nothing special here. Just Min Freq not set correctly. See it often... Spindle max 24000rpm = 10v Spindle recommended min = 7200 rpm 7200 / 24000...
$5=7 (all switches normally open) or $5=0 (all switches NC). Any other values 1-6 inplies some mix of NC and NO mixed (unlikely)
Please contact the Partstore via Support > New Ticket for assistance
Yes, because You have not set up Min Freq on the VFD properly. Pwm is Never 0v thats why every VFD has that setting
You forgot to set VFDs min freq parameters. Should fire up under 100hz for water cooled or 120hz for air cooled. See VFD manual
It should work, screen recording as above You can check it its in the Documentation: docs:blackbox-4x:jumper-autoreset [OpenBuilds Documentation]
Borrow a friends, take it to work. Ask the neighbour.
Works just fine in testing... As it should and always has [ATTACH] The Servo firmware is still 1.1f, so you haven't flashed it (correctly) yet....
Not ANY, Z up as high as it goes, XY at axis maxima would be good too
Check the provided link on this page Interface Mounting Kit Anything will do, we like the size and shape of that one for sticking onto V-Slot
Fantastic (: - but just remember I can't remember all the thousands of people on here's specific setups (; - and will always advocate for others'...
E-Stops MUST cut power. A software pause is useless when the router is busy degloving your hand, or your PSU is on fire. Real history... Not fun
Our screws 8mm Metric Acme Lead Screw are "TR8*8-2p (4 starts)" which is a 4-start screw, with 4x8mm helixes (intertwined you'd see a thread every...
If the holes lines up somewhat, even with some addtional drilling, I'd suggest the existing plate > alu spacer > Spindle body via the bolt holes....
If you want to confirm legitness of any parts, you can check in with the OpenBuilds Partstore. If the last addition of the laser caused things to...
