Separate names with a comma.
Some features disabled for guests. Register Today.
Which soft are you currently using?
lol 10 sec later, found how it worked... I was using sketchup before... so a lot of thing is different ;)
to be honest, I'm new to aspire, I'm not sure I could comment well enough but the vector thing is a pita... Just extending the pocket is...
exactly, I'll try extending! :) Thanks, I was wondering if there was any trick to bypass this =)
Here's my thing to "cut" the cross-sections are a pocket of 2mm. however, when it's cutting around the whole piece and the pocket, it's not...
Thanks I'll take a look at what @sharmstr told me about the shaft couplers and report! Thanks =)
and is there a way to fix/correct the speed of each motor?
Is it possible than Y1 and Y2 motor aren't running at the exact same speed?
you were right. the blue one became loose.
@Alex Chambers I loosen the nut blocks... square it back.. then played with the jog I noticed, while doing y+ y+ y+ ... sometimes the leadscrews...
@Alex Chambers with both y1 and y2 motors connected right and just move y+/y- to see how they behave. I took a look at my main frame, yeah, it...
power off yes, but disconnecting, you mean removing the motor right or just turn the power off? I tried adjusting, the Y axis (y2 motor line). I...
Hi there! :) I am trying to cut some pieces and well.. I noticed it's not cutting at 90 degree angle... I made a little sketchup to show how it...
it was on the collet nut. but if the light of the xyz probe was opened, it was supposed to be stopped isn't it?
Hi all! When I do the auto probe thing, it starts with the Z, then X then Y... but, at Y, it happens 2 out of 5 times that even if the light is...
the woodworking stuff is not greasy, do not stick to wood and so on. You can even paint, oil and so on on it.
worked perfectly with the woodworking stuff ;) not a greasy product so... Gave a few in and out and works like a charm! finally! :) Thanks again!
Thanks! I will test it tomorrow morning! :D I don't have that product on hand eheh Kinda a pita to disassemble this though... Would a...
Hey all, I assembled my lead 1515... When installing the lead screw acme into the nut block, it was pretty hard to screw, had to use glove to be...
Wow! finally... ****, I was banging my head against the wall! lol THANK YOU! :D
