Separate names with a comma.
Some features disabled for guests. Register Today.
The top photo shows no jumper for Plasma Cutter. The second photo shows a jumper for solenoid or water pump. I see you show the jumper in place in...
Yes I did see the documents, however the picture shows no Jumper on the relay pins. Is that correct?
I am turning the Plasma on in the Tool control as well as telling the Gcode that I am operating a Plasma cutter. Is that what you wanted to know?
Do I need any jumpers to activate the Relay. In the photos there does not seem to be required, but I still cannot hear a relay clicking.
I do not hear any clicking like a relay would do. I probably need to hook up 2 of the 4 pins on the plasma machine to your control box. I will...
I suspect the problem is my plasma machine. It has a 2 pin and a 4 pin connectors on the back of the machine and all that the blackbox has is a 2...
Thanks for all the help. For my Delusional Design Freedom 4ft x 4ft table I was able to get the correct size by setting 100 and 101 GRBL settings...
I have looked at all these videos, but none of them show how to make the plasma cutters work with the 4X blackbox. I did hook the relay connector...
How does the Relay plug on the 4X blackbox operate?
What plasma cutting machine is the Blackbox4 designed to work with?
Plasma not triggering. I made sure the plasma on and off was selected and it still is not activating the plasma. Antone had that problem?
Good, so I don't have to update.
Do I need to add or remove any jumpers to update firmware for 4x Blackbox to prevent blackbox damage?
I did use this wizard. When I moved the machine the 100mm the distance between the marks came out to 26 inches between the marks when the software...
My table distance was 26 inches by using the software wizard with the wizard moving the 100mm. That converts 26in to mm = 660.4. So I put that...
So like in the video I need to put a mark at the xyz rails and move them 100mm make a new mark and then measure the distance on the rails and put...
So if I change the feed rate that will change the X and Y travel distance?
Thanks
Are any of the listed tables in the software a 4' x4' table?
My table is still not acting right. From what I get from the manufacture of the table the feed rate is 140 IPM. Where would I put that in? Also...
