Separate names with a comma.
Some features disabled for guests. Register Today.
Search the group (magnifying glass icon top right) for "vinyl cutter" and "drag knife". Alex.
English please. Alex.
See @Peter Van Der Walt's post about grbl settings. Don't use oil on your leadscrews (traps dust) - use a dry silicone or PTFE spray lubricant. Alex.
Grbl always sets a home position. Without running the homing sequence it will set a home position in it's start up position. Link below explains...
Static is another possibility, although more common if you have dust extraction. Good advice in the link @Peter Van Der Walt gave, and definitely...
The Xtension limit switches are definitely a worthwhile investment. If it is emi then identifying the source is a better solution than trying to...
1). not so much a problem with ballscrews, but parts are sometimes stiff when new. 5). if you travel in a circle and don't end up back where you...
Just to add a detail to @Giarc's post - jog as far away from the back, right, up corner of the machine's workspace to find the dimensions of each...
Probing - don't use a bit to probe XY - use an accurately measured rod - actually probe XYZ, switch to the bit then probe Z only. Motors stalling...
Yes - you can still do that.... [ATTACH]
Also, first priority is getting movements in the correct direction. X +ve moves the tool to the right Y +ve moves the tool to the back Z +ve...
First you need to understand the difference between MACHINE co-ordinate system (set by homing) and WORKPLACE coordinates system (XYZ zero set in...
My Great Nephew (8) is into dinosaurs, this T rex head engraved plaque is a Christmas present for his bedroom wall. [ATTACH]
There are different "dialects" of g-code. It is important to use a post processor that creates g-code suitable for your c. What controller,...
Yep, could well be, but more likely if it's building up in the vicinity of the limit switch wiring. If you have any functioning vacuum try to keep...
If I'm reading this right you think that using absolute mode means that the machine will always go to the exact co-ordinates in the g-code....
First question - which post processor are you using with Fusion - you should be using this one;- docs:software:fusion360 [OpenBuilds...
As @Giarc said - cheap calipers are often only accurate to +/- 0.2 mm anyway. Alex.
I notice your g-code file extension is *.tap and there are some codes missing from the header of the g-code file that I would expect from a grbl...
You are not losing steps - once you have lost them you don't get them back again so you would not return to the starting position. The test you...
