Separate names with a comma.
Some features disabled for guests. Register Today.
You don't mention anything about your controller set up but, if it is for example, a grbl controller the g-code will be sent to the controller a...
After moving your homing switches to the corner you want to home to you will need to follow point 3 in @David the swarfer's post. To (hopefully)...
Could you please explain what you expect to happen? G90 (absolute movement mode) and G91 (incremental movement mode) wouldn't stop an axis moving....
Maybe, depends what you want. Message me with details of what you want at looking for. Alex.
I just looked back at your grbl settings. The default MACHINE home position is the back, right, up corner - the maximum dimension for each axis....
Exactly, although, to avoid confusion, I always refer to MACHINE HOME and workplace ZERO. From what I have read in your post I believe your issue...
See @Misterg's post above - when you switch on a grbl controller you automatically create a machine home wherever the machine is at power on, so...
That is a "feature" with some laptop chargers. They create a link between MAINS EARTH and DC GROUND. This can happen with the earth connection to...
You must get travel directions correct first, then correct the homing directions. Alex.
Well it literally means that there is a g-code word in your file that doesn't belong. Either there is a problem with the software you used to...
The first thing to check is the wiring to the X stepper, looking for one loose connection or faulty wire. An intermittent connection can cause...
If you are using the Duet controller there's a post processor (tested with the Duet 2) here -...
Ahh, those jumpers - yes you are correct - Ooznest usually send the Duet board with those already installed. The crimps that Ooznest use (they use...
@Grossvatti, you would have been much better advised to follow the instructions from Ooznest on the Ooznest Learning Portal to upgrade your...
Have you checked the wiring and connectors between the power supply and the Duet. If you have 24V at the power supply end and only 2V at the Duet...
Yes, you might have a short circuit so check the wiring (power OFF!) first. If you are sure there is no short turn the current down -...
Do you mean software to control the machine (see @Giarc's answer) or cad/cam software to design things and create the g-code that the Blackbox...
The error message says that you triggered a limit switch, either by running into it or accidentally touching it. Alex.
The wheels on your X gantry are loose - adjust the eccentrics on those. Alex.
Yes, homing sets the back, right, up corner as a reference point for the MACHINE co-ordinate system. Your job runs in a WORKPLACE coordinate...
